Pioneer DV-410V-K Operating Instructions Manual

Contents

0947EnEnglishHDMI troubleshooting(DV-410V only)Cannot output 96 kHz or88.2 kHz digital audio.• Check that 96kHz PCM Out is set to 96kHz (page 36).• Some discs are digital copy protected and do not output highsampling rate digital audio. In this case the output is automaticallydownsampled.No DTS audio output. • If this unit is connected to a non-DTS compatible amplifier ordecoder using a digital audio cable, set DTS Out to DTS > PCM/Off(page 36). If you do not do this, noise will be output when you play aDTS disc.• If this unit is connected to a DTS-compatible amplifier or decoderusing a digital audio cable, check the amplifier settings, and thatthe cable is properly connected.Can’t hear effect of VirtualSurround.• The Virtual Surround effect is only output through theAUDIO OUT L/R analog audio outputs.• The effectiveness of Virtual Surround varies with the disc.Problem RemedyProblem RemedyNo HDMI audio output. • Check whether or not HDMI Out is set to Off (page 36).• This unit has been designed to be compliant with HDMI(High-Definition Multimedia Interface). Depending on thecomponent you have connected, unreliable signal transfers mayresult.• If the front panel HDMI indicator is lit:– You won’t hear any sound from the HDMI output if the sourcecomponent is only DVI/HDCP-compatible.• If the front panel HDMI indicator is unlit then:– Make sure that you’ve selected this player as the HDMI input inthe settings for the component you’re using. You may need to referto the instruction manual of the component to do this.– Check that the HDMI cable is connected properly and that thecable isn’t damaged.– Check that components connected using the HDMI interface areswitched on and HDMI compatible.