INSTALLATION MANUALINSTALLATION MANUALDEH-P3000IB <07H00000>Printed in China ESInstallation English Installation EnglishNote• Check all connections and systems before finalinstallation.• Do not use unauthorized parts. The use ofunauthorized parts may cause malfunctions.• Consult with your dealer if installation requiresdrilling of holes or other modifications of thevehicle.• Do not install this unit where:— it may interfere with operation of the vehicle.— it may cause injury to a passenger as a resultof a sudden stop.• The semiconductor laser will be damaged if itoverheats. Install this unit away from hot placessuch as near the heater outlet.• Optimum performance is obtained when the unit isinstalled at an angle of less than 60°.60°• When installing, to ensure proper heat dispersalwhen using this unit, make sure you leave amplespace behind the rear panel and wrap any loosecables so they are not blocking the vents.DIN Front/Rear-mountThis unit can be properly installed either from"Front" (conventional DIN Front-mount) or"Rear" (DIN Rear-mount installation, utilizingthreaded screw holes at the sides of unitchassis). For details, refer to the followinginstallation methods.DIN Front-mountInstallation with the rubber bush1. Insert the mounting sleeve into thedashboard.• When installing in a shallow space, use asupplied mounting sleeve. If there is enoughspace behind the unit, use factory suppliedmounting sleeve.2. Secure the mounting sleeve byusing a screwdriver to bend themetal tabs (90°) into place.3. Install the unit as illustrated.535311182182Removing the Unit1. Extend top and bottom of the trimring outwards to remove the trimring. When reattaching the trim ring,push the trim ring onto the unit untilit clicks. (If the trim ring is attachedupside down, the trim ring will notfit properly.)• It becomes easy to remove the trim ring if thefront panel is released.2. Insert the supplied extraction keysinto both sides of the unit untilthey click into place.3. Pull the unit out of the dashboard.DIN Rear-mount1. Extend top and bottom of the trimring outwards to remove the trimring. When reattaching the trim ring,push the trim ring onto the unit untilit clicks. (If the trim ring is attachedupside down, the trim ring will notfit properly.)• It becomes easy to remove the trim ring if thefront panel is released.2. Determine the appropriate positionwhere the holes on the bracket andthe side of the unit match.3. Tighten two screws on each side.• Use either truss screws (5 mm × 8 mm)or flush surface screws (5 mm × 9 mm),depending on the shape of screw holes in thebracket.Dashboard Mounting sleeveRubber bushScrewTrim ringTrim ringDashboard or ConsoleFactory radio mounting bracketScrew
