Pioneer DEH-2100 Installation Manual

Also see for DEH-11: Operation manual Service manual Service manual

Note:• This unit is for vehicles with a 12-volt batteryand negative grounding. Before installing it in arecreational vehicle, truck, or bus, check the bat-tery voltage.• To avoid shorts in the electrical system, be sureto disconnect the ≠ battery cable before begin-ning installation.• Refer to the owner’s manual for details on con-necting the power amp and other units, thenmake connections correctly.• Secure the wiring with cable clamps or adhesivetape. To protect the wiring, wrap adhesive tapearound them where they lie against metal parts.• Route and secure all wiring so it cannot touchany moving parts, such as the gear shift, hand-brake and seat rails. Do not route wiring inplaces that get hot, such as near the heater outlet.If the insulation of the wiring melts or gets torn,there is a danger of the wiring short-circuiting tothe vehicle body.• Don’t pass the yellow lead through a hole intothe engine compartment to connect to the battery.This will damage the lead insulation and cause avery dangerous short.• Do not shorten any leads. If you do, the protec-tion circuit may fail to work when it should.• Never feed power to other equipment by cuttingthe insulation of the power supply lead of theunit and tapping into the lead. The current capac-ity of the lead will be exceeded, causing over-heating.• When replacing fuse, be sure to use only fuse ofthe rating prescribed on this unit.• Since a unique BPTL circuit is employed, neverwire so the speaker leads are directly groundedor the left and right ≠ speaker leads are com-mon.• Speakers connected to this unit must be high-power types with minimum rating of 40 W(45 W)* and impedance of 4 to 8 ohms.Connecting speakers with output and/or imped-ance values other than those noted here mayresult in the speakers catching fire, emittingsmoke, or becoming damaged.* DEH-2100 and DEH-21• When this product’s source is switched ON, acontrol signal is output through the blue/whitelead. Connect to an external power amp’s systemremote control or the car’s Auto-antenna relaycontrol terminal. (Max. 300 mA 12 V DC.) If thecar features a glass antenna, connect to the anten-na booster power supply terminal.• When an external power amp is being used withthis system, be sure not to connect the blue/whitelead to the amp’s power terminal. Likewise, donot connect the blue/white lead to the power ter-minal of the auto-antenna. Such connection couldcause excessive current drain and malfunction.• To avoid short-circuiting, cover the disconnectedlead with insulating tape. Especially, insulate theunused speaker leads without fail. There is a pos-sibility of short-circuiting if the leads are notinsulated.• If this unit is installed in a vehicle that does nothave an ACC (accessory) position on the ignitionswitch, the red lead of the unit should be con-nected to a terminal coupled with ignition switchON/OFF operations. If this is not done, the vehi-cle battery may be drained when you are awayfrom the vehicle for several hours.• The black lead is ground. Please ground this leadseparately from the ground of high-current prod-ucts such as power amps.If you ground the products together and theground becomes detached, there is a risk of dam-age to the products or fire.• Cords for this product and those for other prod-ucts may be different colors even if they have thesame function. When connecting this product toanother product, refer to the supplied Installationmanuals of both products and connect cords thathave the same function.No ACC positionACC positionONSTARTOFFACCONSTARTOFF+≠+≠≠+ +≠≠+ +≠Connecting the UnitsINSTALLATION MANUALMANUEL D’INSTALLATIONConnection DiagramDEH-2100DEH-1100DEH-21DEH-11<99K00T0T01>Printed in U.S.A.Imprimé aux Etats-Unis

This product conforms to CEMA cord colors.Le code de couleur des câbles utilisé pour ce produitest conforme à CEMA.Los colores de los cables este producto se conformancon el código de colores CEMA.This ProductRear outputAntenna jack FuseBlack (ground)RedYellowTo terminal always supplied with powerregardless of ignition switch position.To electric terminal controlled by ignitionswitch (12 V DC) ON/OFF.To vehicle (metal) body.With a 2 speaker system, do not connectanything to the speaker leads that are notconnected to speakers.Perform these connections when using a different amp (sold separately).To system control terminal ofthe power amp or Auto-antennarelay control terminal.(Max. 300 mA 12 V DC.)Connecting cords with RCApin plugs (sold separately)Blue/whiteSystem remote controlPower amp(sold separately)WhiteWhite/blackGreenGreen/blackGrayGray/blackVioletViolet/blackFrontspeakerRearspeakerRightRearspeakerRearspeakerFrontspeakerRearspeakerLeftFuse holder