Pioneer DDJ-WEGO3 Operating Instructions Manual

Also see for DDJ-WEGO3: Operation guide Operating instructions Operating instructions Firmware update procedures Setup guide

En 7EnglishConnecting with a computerSince the iPhone/iPad connection has priority, do not connect an iPhone/iPad to the unit when using a computer.For audio outputFor checkingthe output sound For audio inputDJ softwareRLR LUSBTo poweroutletHeadphonesPower cord(included)Component, amplifier,powered speaker, etc.To headphonesHeadphones cord AC adapter (included)USB cable (included)Computer MicrophoneTo microphoneMicrophone cableRear panelAudio inputSide panelLeft(L) Right(R)Audio cableTo audio inputterminalsTo USB port1 PHONES terminalsConnect headphones here.Both stereo phone plugs (Ø 6.3 mm) and stereo mini phone plugs(Ø 3.5 mm) can be used.! Connect headphones with an impedance of 32 W or more.Headphones with an impedance of less than 32 W are notsupported.! Do not connect headphones simultaneously to the stereo phonejack and the stereo mini-phone jack.2 Cord hookSecure the AC adapter’s power cord and USB cable on this hook.! The sound will be interrupted if the AC adapter’s power cord orUSB cable is disconnected from the unit during playback.3 DC IN terminalConnect the included AC adapter’s DC plug here. Wait until all con-nections of the equipment are completed before connecting thepower cord.Be sure to use the power cord and AC adapter included with thisproduct.4 USB terminalWhen using a computer! Connect this unit and the computer directly using the includedUSB cable.! A USB hub cannot be used.When using an iPhone/iPad! If not using an AC adapter, connect this unit and a USB mobilebattery or USB power adapter using the included USB cable.! If power is supplied by USB bus power, iPhone/iPad rechargingcannot be performed. To recharge the iPhone/iPad, use an ACadapter.! USB bus power must have a power supply capacity ofDC 5 V/500 mA or greater. Note that depending on the capacityand charging status of the product being used, operation may beunstable.5 iOS DEVICE terminalConnect this unit with the iPhone/iPad using the iPhone/iPad con-nection cable.6 Kensington security slot7 MASTER OUT terminalsConnect powered speakers, etc., here.8 MIC terminalConnects a microphone here.! Only the volume of the microphone’s sound can be adjusted.! Supports unbalanced input only.Caution when using the iPhone/iPadstandiPhone/iPad stand! This stand is exclusively for use with an iPhone/iPad. Do not placetablets other than iPad or large devices on the stand.! Set the iPhone/iPad on the stand in the horizontal direction. It maybe unstable if set in the vertical direction.! Do not apply excessive force to the stand. Doing so may damage thisunit.! Please note that Pioneer will accept no responsibility whatsoever fordamage to or malfunction of the device, injury, etc., due to the devicefalling, etc.! Do not move with an iPhone/iPad placed on the stand. The iPhone/iPad could fall off.! If there is a cover on the iPhone/iPad, remove the cover before plac-ing the iPhone/iPad on the stand. If the cover is left on, the iPhone/iPad could be unstable.Using the cord hookFasten the AC adapter’s power cord and USB cable in place by hookingthem on the cord hook. This prevents the power cord and USB cablefrom being accidentally pulled and the plugs from being disconnectedfrom the terminals.AC adapter’s power cordCord hook USB cable