Pioneer BDR-203 Command Reference Manual

BDR-203/BDC-203 Command Reference Manual Version 0.90Page 324.12.2 Mode PagesThe drive is not supported the Parameters Savable (PS) bit and must be set to zero.The Page Code field identifies the format and parameters defined for that mode page.The drive supports following Mode pages.Table 31 - Mode Page CodesPage code Description Section01h Error Recovery Page 4.12.2.2 on page 3105h Write Parameters Page 4.12.2.5 on page 3208h Caching Page 4.12.2.1 on page 310Eh CD Audio Control Page See SFFC INF-8090i document1Ah Power Condition Page 4.12.2.3 on page 311Dh Time-out & Protect Page 4.12.2.4 on page 312Ah Capabilities & Mechanical Status Page 4.12.2.6 on page 333Fh Return all pages (valid only for the MODE SENSE command)4.12.2.1 Caching PageThe Caching Page is supported for compatibility of other CD-R/RW drive. This page has no effect on write/read operation. Thereturned Caching parameters by the MODE SENSE (10) Command are modified to the new parameters after receiving newparameters by MODE SENSE (10) Command.Table 32 - Caching ParameterBitByte7 6 5 4 3 2 1 00 PS Reserved Page Code = 08h1 Page Length = 0Ah2 IC ABPF CAP DISC SIZE WCE MF RCD3 Demand Read Priority Write Retention Priority4 (MSB)5 Disable Pre-fetch Transfer Length (LSB)6 (MSB)7 Minimum Pre-fetch (LSB)8 (MSB)9 Maximum Pre-fetch (LSB)10 (MSB)11 Maximum Pre-fetch Ceiling (LSB)Default value of the WCE bit is one. Default value of any other bits and field is zero.4.12.2.2 Error Recovery Parameters PageThe AWRE and ARRE bits are not supported and are ignored.The TB, RC, DTE and DCR bits are ignored.The PER bit and EMCDR field are used to control the defect reporting.Setting value of the Read Retry Count and the Write Retry Count field are ignored.4.12.2.3 Power Condition PageThe default value of an Idle bit is one. The default value of the Idle Timer field is 000000c8h (20 second).The default value of the Standby bit is one. The default value of Standby Timer field is 000012C0h (8 minutes).4.12.2.4 Time-out & Protect PageThe DISP, SWPP bits are not supported and must be set to 0.Pioneer Confidential