Menu
Pioneer AirTies 4920 Installation Manual
  |
It may take up to 24-hours for your new WiFi Meshsystem to optimize to your network!It is recommended that you follow the coverage guideline of 1,200 square feet per access point device.1. Disable the existing Gateway/router’s “Internet” WiFi function. Instructions on disabling Pioneer’sGateway WiFi can be found at under the Routers section at www.gopioneer.com/support. (Managethe ZyXEL Gateway WiFi Settings)2. Using the enclosed Ethernet cable, connect an AirTies 4920 access point (AP) to a GIGE LAN port onthe back of the Pioneer Gateway or your personal router and power on the AP.NOTE: The primary AP must be connected to the Gateway/router prior to pairing additional AP’susing WPS.NOTE: If you have Pioneer DTV service, plug the Ethernet cable into Port 4.3. To begin the syncing process on the 2nd AP, plug it into a power source. On the APconnected directly to the Gateway/router, press and hold the WPS button for 3seconds and until the 2.4GHz and 5GHz LEDs blink in sync, then do the same for the2nd AP being configured. Within 3 minutes, the 5GHZ LEDs on both Aps should turnsolid GREEN indicating a successful mesh link between the APs.Press & hold the WPS buttonfor 3seconds until 2.4 GHz and 5 GHzLEDs blink in sync.4. Configure additional mesh Aps by repeating steps 3 and 4.5. Place 1 AP on each floor OR 1 AP per 1,200 square ft. for optimal coverage ensuring a solid GREEN5GHz LED on all AP device. A solid GREEN LED indicates each AP has at minimum one strong link tothe next device. |
Related manuals for Pioneer AirTies 4920
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved