684 Select “Yes” and click the OK button.Alternative option:5 Enter a new name; select “OK” and click the OK button.The name of the current location appears in the text box. Delete the current name, andenter a new name between 6 and 23 characters long. (For the details of entering charac-ters, see “How to use the text palette” on page 35.)When you click the OK button, a message confirming the new name appears, and a voicemessage confirming the pronunciation of the name is played.6 If the pronunciation is correct, select “Yes” and click the OK button.The details you set are registered, and the Address Book menu appears. On the map, a pinmark appears at the registered location. (You can change this mark.)On this display, you can select following options:➲ In the Address Book, you can register up to 298 locations, except your home and yourfavorite location.➲ When you change the name, a mark is shown on the left side of the location name dis-played in the Address Book menu. This mark indicates that this name can be used as avoice command during voice operation.➲ During voice operation, you can get a route calculated by saying the registered name. Forthe details of voice operation, see Chapter 7.➲ If you register a location by selecting “Register” from the Shortcut menu, select “EditName” and perform the operations in step 5 and 6; you can get a route calculated by say-ing the registered name.➲ You can also store locations registered in the Address Book on a PC card (see “Storing thedata of registered locations in the PC card” on page 88).No : If you do not need to rename, select “No”. The name of the location registered in theAddress Book is unchanged, and the Address Book menu appears.No : Select to return to the display for entering characters.Repeat : You can reconfirm the pronunciation of the name you entered.
