2SHUDWLQJWKH6\VWHPE\9RLFHSetting a Route and Displaying Points of Interest by VoiceYou can use voice commands to set a route in much the same way as described in “Settng a Routeto Your Destination”. You may also overlay a specific category of points of interest on the mapby voice.• You can easily set a route home, to the stored location, or to any listing in the Destination history thathas been specifically named. (See “Settng a Route to Your Destination” for details of the Destinationhistory and the home and stored locations.) Activating voice recognitionIn a case where no route has yet been set, you can activate voice recognition whenever theDestination menu or the map is displayed. 3UHVVWKHH 7$/. EXWWRQRQ\RXU1DYLJDWLRQFRPPDQGHUThe Voice Recognition menu appears (countdown lamps light and change colour one by one),giving a list of the available options.The commands that can be given are the following:• RETURN HOMEFind a route home from your current location. (This appears only if a home location has beenregistered; see “Registering your home location” on page 27.)• GO TO (registered location name)Find a route to the stored location. (This appears only if a specific location has beenregistered; see “Registering locations” on page 52.)• DESTINATION HISTORYFind a route to a ticked and named listing in the Destination history.• DISPLAY POINTS OF INTERESTOverlay a category of point of interest on the map.• Remember to give your command before all the countdown lamps have changed colour.• If you fail to give a voice command before all the countdown lamps have changed colour, the VoiceRecognition menu disappears and the Destination menu or Map display appears once again.