Pioneer 507CMX - PDP - 50" Plasma Panel Operating Instructions Manual

Also see for PDP 607CMX: Operating instructions Brochure & specs Technical manual Reference manual

Contents

9EnPart Names and Functions EnglishCOMBINATIONIN OUTRS-232C AUDIO AUDIOINPUT1AUDIOOUTPUT INPUT2ANALOG RGB OUT(D-Sub)ANALOG RGB IN(D-Sub)INPUT1DIGITAL RGB(DVI-D)INPUT24=-21 8 9 03 5671 SPEAKER (R) terminalFor connection of an external right speaker.Connect a speaker that has an impedance of 6 Ω(page 14).2 SPEAKER (L) terminalFor connection of an external left speaker. Connect aspeaker that has an impedance of 6 Ω (page 14).3 COMBINATION IN/OUTNever connect any component to theseconnectors without first consulting your Pioneerinstallation technician.These connectors are used for Plasma Display setupadjustments.4 RS-232CNever connect any component to this connectorwithout first consulting your Pioneer installationtechnician.This connector is used for Plasma Display setupadjustments.5 AUDIO (OUTPUT) (Stereo mini jack)Use to output the audio of the selected sourcecomponent connected to this unit to an AV amplifieror similar component.Note: No sound is produced from the AUDIO (OUTPUT) jackwhen the MAIN POWER switch is set to OFF or ON (standby)(page 14).6 AUDIO (INPUT1) (Stereo mini jack)Use to obtain sound when INPUT1 is selected.Connect the audio output jack of componentsconnected to INPUT1 to this unit (page 14).Connection panel (PDP-507CMX)The connection panel is provided with two video inputterminals and one video output terminal. Audio input/output and speaker output terminals are also provided.For instructions regarding connections, consult the pagesnoted in parentheses by each item.7 AUDIO (INPUT2) (Stereo mini jack)Use to obtain sound when INPUT2 is selected.Connect the audio output jack of componentsconnected to INPUT2 to this unit (page 14).8 ANALOG RGB OUT (INPUT1) (mini D-sub 15 pin)Use the ANALOG RGB OUT (INPUT1) terminal tooutput the video signal to an external monitor or othercomponent.Note: The video signal will not be output from the ANALOGRGB OUT (INPUT1) terminal when the main power of thisunit is off or in standby mode.(page 13)9 ANALOG RGB IN (INPUT1) (mini D-sub 15 pin)For connection of a personal computer (PC) or similarcomponent. Make sure that the connection madecorresponds to the format of the signal output fromthe connected component (page 13).0 DIGITAL RGB (INPUT2) (DVI-D jack)Use to connect a computer.Note: This unit does not support the display ofcopyguard-protected video signals (page 13).- AC INUse to connect the supplied power cord to an ACoutlet (page 15).= MAIN POWER switchUse to switch the main power of the unit on and off.Part Names and Functions