Tone configuration task list 335SmartWare Software Configuration Guide 26 • Tone configurationConfigure tone-set profilesA tone-set profile maps one call-progress-tone profile to each internal call-progress-tone. A tone-set profile typ-ically includes all the call-progress-tones for one country.This procedure describes how to configure a tone-set profileMode: ConfigureExample: Configuring a tone-setThe following example shows how to configure a tone-set profile for UK.SN(cfg)#profile tone-set UKSN(pf-tones)[swiss]#map call_progress_tone dialtone dialUKSN(pf-tones)[swiss]#map call_progress_tone alertingtone ringUKSN(pf-tones)[swiss]#map call_progress_tone busytone busyUKEnable generation of local in-band tonesThe SmartNode will always generate the tones locally (as programmed in the tone-set profile) if in-band tonegeneration is enabled (command ‘local-inband-tones’) irrespective of the presence or absence of in-band tonesfrom the IP network.If local in-band tones are disabled (command ‘no local-inband-tones’) tones are played nevertheless in the fol-lowing situations:• Dial tone:The dial tone is played towards the calling party if the SessionRouter requires more digits todetermine the outgoing interface• Alerting tone:The alerting tone is played towards the calling-party if faststart is not enabled• Busy tone:The busy tone is played towards the calling-party if Q.931-tunneling is not enabledFor enabling generation of local in-band tones first you have to assign a tone-set profile to the CS context or aCS interface, and second enable local in-band tone generation with the ‘local-inband-tones’ command.Note The profile used in the CS context applies to all PSTN interfaces on the CScontext. If you want to override this tone configuration on individual inter-faces proceed as follows.This procedure describes how to assign a tone-set profile to the CS context and to a CS interfaceStep Command Purpose1node(cfg)#profile tone-setname Creates tone-setname and enters tone-set profileconfiguration mode.2node(pf-tones)[name]#mapcall_progress_tone{dialtone|alertingtone|busytone}call-progress-toneMap a call-progress-tone profile to an internaltone. An internal tone represents the call event forwhich a tone indication can be provided. Use theCLI help to get a list of all available events.3 Repeat step 2 for all internal tone events.
