Patton electronics SmartNode 4520 Series User Manual

Also see for SMARTNODE 4110 Series: Quick start guide Getting started guide User manual Getting started guide Getting started guide

Contents

Patton electronics SmartNode 4520 Series User Manual Manual pdf 40 page image

1. Configure IP address 40SmartNode 4520 & 4110 Series User Manual 4 • Getting started with the SmartNode1. Configure IP addressCAUTIONThe Interconnecting cables shall be acceptable for external useand shall be rated for the proper application with respect to volt-age, current, anticipated temperature, flammability, andmechanical serviceability.Power connection and default configurationFirst the SmartNode must be connected to the mains power supply with the power cable. Wait until the 'Run'LED stops blinking and lights constantly. Now the SmartNode is ready.The factory default configuration for the Ethernet interface IP addresses and network masks are listed in table 8.Table 8. Factory default IP address and network mask configurationIP Address Network MaskInterface Ethernet 0 (ETH0) DHCP DHCPInterface Ethernet 1 (ETH1) 192.168.1.1 255.255.255.0Both Ethernet interfaces are activated upon power-up.If these addresses match with those of your network, go to section “2. Connect the SmartNode to the network”on page 41. Otherwise, refer to the following sections to change the addresses and network masks.Connect with the serial interfaceThe Console port is wired as an EIA-561, RS-232 port. Use the included Model 16F-561 adapter and cable (seefigure 25) between the SmartNode’s Console port and a PC or workstation’s RS-232 serial interface. Activate theterminal emulation program on the PC or workstation that supports the serial interface (e.g. HyperTerm).ConsoleVoIP Gateway RouterToIP Integrated Access DeviceSmartNode 4524Link100MActivity0/0 0/1 0/2 0/3Enet 0Voice PortsPowerRunVoIP LinkLink100MActivityEnet 1Figure 25. Connecting to the terminalTerminal emulation program settings:• 9600 bp• no parity