Patton electronics SmartNode 4400 Getting Started Manual

Also see for SmartNode 4400: Quick start guide Getting started guide Quick start guide

Contents

Patton electronics SmartNode 4400 Getting Started Manual Manual pdf 36 page image

Introduction 36SmartNode 4400 Series Getting Started Guide 4 • Getting started with the SmartNode 4400 SeriesIntroductionThis chapter leads you through the basic steps to set up a new SmartNode and to download a configuration.Setting up a new SmartNode consists of the following main steps:Note If you have not already installed the SmartNode, refer to chapter 3,“Hardware installation” on page 24.1. Configuring the desired IP address (see figure 14). Refer to section “2. Connecting the SmartNode tothe network” on page 40 for details.Figure 14. Connecting the SmartNode to your laptop PC2. Connecting the SmartNode to the network (see figure 15). Refer to section “1. Configure IP address” onpage 37 for details).Figure 15. Connecting the SmartNode to the networkConsole portLaptop PCModel 16F-561adapter and cable100-240V(50-60 Hz)1 AMPUNIT EQUIPPED WITH DUAL SUPPLIESDISCONNECT BOTH SUPPLIESBEFORE SERVICINGETH 0/0ConsoleTelco Ports50ResetETH 0/1100-240V(50-60 Hz)1 AMPUNIT EQUIPPED WITH DUAL SUPPLIESDISCONNECT BOTH SUPPLIESBEFORE SERVICINGETH 0/0ConsoleTelco Ports50ResetETH 0/1LAN (ETH 0/1)NetworkinterfacePC or workstationor TelnetLANInternet orWAN (optional)WAN(ETH 0/0)