Patton electronics SMARTNODE 5400 Getting Started Manual

Contents

Patton electronics SMARTNODE 5400 Getting Started Manual Manual pdf 17 page image

SmartNode 5400 rear panel 17SmartNode 5400 Getting Started Guide 1 • General informationTable 3. Rear panel portsPort DescriptionWAN ETH 0/0 Auto-MDX Gigabit-Ethernet port, RJ-45 (see figure 1), connects the unit to an EthernetWAN device (for example, a cable modem, DSL modem, or fiber modem). Note:Only full duplex modes are supported.LAN ETH 0/1 Auto-MDX Gigabit-Ethernet port, RJ-45 (see figure 1), connect the unit to an EthernetLAN (for example, a PC, printer, or wireless bridge). Note: Only full duplex modesare supported.Console Used for service and maintenance, the Console port (see figure 1), an RS-232 RJ-45connector, connects the product to a serial terminal such as a PC or ASCII terminal(also called a dumb terminal).Reset The reset button (see figure 1) has three functions:• Restart the unit with the current startup configuration—Press (for less than 1 second)and release the Reset button to restart the unit with the current startup configuration.• Restart the unit with factory default configuration—Press the Reset button for5 seconds until the Power LED (see figure 2 on page 18) starts blinking to restartthe unit with factory default configuration.• Restart the unit in bootloader mode (to be used only by trained SmartNode tech-nicians)—Starting with the unit powered off, press and hold the Reset button asyou apply power to the unit. Release the Reset button when the Power LED startsblinking so the unit will enter bootloader mode.G.SHDSL port(option)Provides up to 11.4 Mbps (on 4 wires) and 5.7 Mbps (on 2 wires) symmetricalthroughput, supporting ATM QoS. Supports multiple PVC and DSLAM interoperabil-ity. The G.SHDSL LEDs are located on either side of the DSL port. ACT (when lit orblinking) shows Activity, and LINK (when lit) shows that the DSL port is connected.