Patton electronics RocketLink-G 3088 Series Quick Start Manual

Also see for RocketLink-G 3088 Series: User manual User manual

Contents

Patton electronics RocketLink-G 3088 Series Quick Start Manual Manual pdf 2 page image

2 Model 3088 Quick Start Guide1.0 Select configuration methodBefore powering up, you must select one of the following methods for configuring your RocketLink-G:• Plug ‘n’ Play—The RocketLink-G comes factory-configured for Plug ’n’ Play configuration when connectedto a service-provider network.• DIP Switch—For deploying the RocketLink-G in back-to-back applications. To use DIP-switch configurationyou must first set the DIP switches to a position other than all OFF or all ON before powering-up the Rock-etLink-G. To configure your NTU using the DIP switches, refer to the section entitled “Hardware (DIP-switch)configuration” in the RocketLink-G Model 3088 Series Getting Started Guide.• Software Configuration—Allows you to modify configurable parameters by connecting a PC to the con-sole port and issuing software commands. To use software configuration you must set all the DIP switches tothe ON position before powering-up the RocketLink-G. To configure your NTU via the console port, refer tosection “Software (CLI) configuration” in the RocketLink-G Model 3088 Series Getting Started Guide.• This device contains no user serviceable parts. The equipmentshall be returned to Patton Electronics for repairs, or repairedby qualified service personnel.• AC Powered Units: The external power adaptor shall be alisted Limited Power Source. Ensure that the power cable usedmeets all applicable standards for the country in which it is tobe installed, and that it is connected to a wall outlet which hasearth ground. The mains outlet that is utilized to power thedevice shall be within 10 feet (3 meters) of the device, shallbe easily accessible, and protected by a circuit breaker.• DC Powered Units: The interconnecting cables shall be ratedfor proper voltage, current, anticipated temperature, flamma-bility, and mechanical serviceability.• Hazardous network voltages are present in WAN ports,regardless of whether power to the unit is ON or OFF. To avoidelectric shock, use caution when near WAN ports. Whendetaching the cables, detach the end away from the devicefirst.• Do not work on the system or connect or disconnect cables dur-ing periods of lightning activity.WARNING