Patton electronics Patton SmartNode 4960 Series Getting Started Manual

Also see for SmartNode 4960 Series: Manuel de configuration simplifié Quick start guide Getting started guide Quick start guide

Contents

Patton electronics Patton SmartNode 4960 Series Getting Started Manual Manual pdf 33 page image

Bootloader 34SmartNode 4960 Getting Started Guide 4 • Initial configuration172.16.1.99(if-ip)[WAN]#reloadRunning configuration has been changed.Do you want to copy the 'running-config' to the 'startup-config'?Press 'yes' to store, 'no' to drop changes : noPress 'yes' to restart, 'no' to cancel : yesThe system is going downBootloaderThe bootloader ensures that basic operations, network access, and downloads are possible in case of interruptedor corrupted application image downloads. It offers console access to the Bootloader and the capability fordownloading application images (e.g. SmartWare) via the serial link of the console.Start BootloaderTo start the Bootloader, power on the SmartNode while pressing the reset button. Open a Telnet session to theSmartNode via one of the Ethernet interfaces, or open a CLI session via the console port (if available on theSmartNode). The login display will appear. Using the credentials admin / patton , log in to the SmartNode.The following prompt will be displayed:RedBoot>Type help to display an overview of the available commands.Start-up with factory configurationLoad a new application image (SmartWare) via TFTPThe following procedure downloads the application image (SmartWare) for the mainboard. See the note belowon how to download the respective CLI description file.Step Command Purpose1 RedBoot> fis load Copies the SmartWare application image from thepersistent memory (flash:) to the volatile memory(RAM) from where it will be executed.2 RedBoot> go -s factory-config Starts the SmartWare application telling it to use‘factory-config’ as startup configuration.You can also start-up with any other configurationavailable in the persistent memory (nvram:) by pro-viding its name instead of ‘factory-config’.Step Command Purpose1optionalRedBoot> ip_address - llocal_ip_address [/mask_len]Sets the IP address and subnet mask of theEthernet interface 0/0 which shall be used toreceive the new application image.mask_len is the length of the network address(or the number of 1’s within the subnet mask).See Note below.