Parkside PDKS 6.0 A1 Operation And Safety Notes

Also see for 110140: Operation and safety notes Operation and safety notes Operation and safety notes Operation and safety notes

Contents

Parkside PDKS 6.0 A1 Operation And Safety Notes Manual pdf 10 page image

10 GB/IEBefore use / Start-up / After initial useBefore useInstallationThe device itself is fully functional at delivery. Usingthe device may require (unless already installed) in-stalling a threaded plug nipple 5 (note the dataunder technical details for the fit / size).Wrap the threaded plug nipple 5 with Teflontape (not included) before screwing it into theair tool. Wrap the tape around the thread astight as possible. This will minimise the likelihoodof air leaking and optimise the work process.Now screw the threaded plug nipple 5 intothe power tool.Tighten the threaded plug nipple 5 to the airtool with a size 14 key using moderate force(see Fig. A).Adjusting the compressed air supply andconnectionsOnly use filtered, lubricated and regulatedcompressed air.Connect to the compressed air system using themethod shown in Figure B. This will increasethe effectiveness and life of the tool.Set your compressor to the working pressurespecified for the device under technical data.Please note, on average the pressure for 10 mof hose will decrease by about 0.5 bar.Excessive pressure isdangerous! Never exceed the specifiedpressure!Add a few drops of air tool oil or SAE 10–20engine oil to the compressed air connection ofthe air tool before first use and in regular intervals.Using other oil (particularly higher viscosity) willresult in damage or even total loss of the device.Start-upConnecting thecompressed air toolVerify the work piece is correctly supported.Connect to compressed air by pushing on thequick couple of the hose using a little force(see Fig. C).Always verify the compressed air hose is properlyconnected (see Fig. D). A loose hose whippingabout out of control presents a major hazard.The threaded plug nipple 5 must be firmlyseated for the same reason. This must also bechecked.CuttingNote: The trigger 4 features a safety stop. Usingthe trigger 4 requires pushing the lever on the trig-ger 4 (safety stop) forward whilst pushing downon the trigger 4 .Activate the trigger 4 to operate the saw.Note: Metal slivers flying about can be verydangerous!Note: If the compressed air supply is tempo-rarily cut off due to power failure or temporarycompressor failure, immediately release thetrigger 4 . You must now first pull the saw allthe way out of the work piece to continue work-ing. You can then continue working.Always check the saw blade position after2 minutes of continuous operation.After finishing the task, release the trigger 4 tostop the saw from running.After initial useOnce the task has been finished the device must bedisconnected from the compressed air connection.This first requires the pressure to be completely re-leased from the lines.Briefly activate the trigger 4 on the device torelease any remaining compressed air.110140_par_Druckluft-Saege PDKS 6.0 A1_content_FI_SE_DK.indd 10 08.07.15 09:10