Parkside PBSG 95 C3 Translation Of The Original Instructions

Also see for PBSG 95 C3: Translation of the original instructions

Contents

Parkside PBSG 95 C3 Translation Of The Original Instructions Manual pdf 8 page image

8 GBNon-skid footwear is recommended whenworking outdoors.Wear protective hair covering to containlong hair.9. Use protective equipmentUse safety glasses.Use face or dust mask if working operationscreate dust.10. Connect dust extraction equipmentIf the tool is provided for the connection ofdust extraction and collecting equipment,ensure these are connected and properlyused.11. Do not abuse the cordNever yank the cord to disconnect it fromthe socket. Keep the cord away from heat,oil and sharp edges.12. Secure workWhere possible use clamps or a vice to holdthe work. It is safer than using your hand.13. Do not overreachKeep proper footing and balance at alltimes.14. Maintain tools with careKeep cutting tools sharp and clean forbetter and safer performance.Follow instruction for lubricating and chang-ing accessories.Inspect tool cords periodically and if dam-aged have them repaired by an authorizedservice facility.Inspect extension cords periodically andreplace if damaged.Keep handles dry, clean and free from oiland grease.15. Disconnect toolsWhen not in use, before servicing andwhen changing accessories such as blades,bits and cutters, disconnect tools from thepower supply.16.Remove adjusting keys andwrenchesForm the habit of checking to see that keysand adjusting wrenches are removed fromthe tool before turning it on.17. Avoid unintentional startingEnsure switch is in “off’ position whenplugging in.18. Use outdoor extension leadsWhen the tool is used outdoors, use onlyextension cords intended for outdoor useand so marked.19. Stay alertWatch what you are doing, use commonsense and do not operate the tool whenyou are tired.20. Check damaged partsBefore further use of tool, it should becarefully checked to determine that it willoperate properly and perform its intendedfunction.Check for alignment of moving parts,binding of moving parts, breakage of parts,mounting and any other conditions thatmay affect its operation.A guard or other part that is damagedshould be properly repaired or replaced byan authorized service centre unless other-wise indicated in this instruction manual.Have defective switches replaced by anauthorized service centre.Do not use the tool if the switch does notturn it on and off.21. WarningThe use of any accessory or attachmentother than one recommended in this instruc-tion manual may present a risk of personalinjury.