Parkinson Cowan SG 454 Operating And Installation Instructions

Also see for SG 454: Operating and installation instructions

Parkinson Cowan SG 454 Operating And Installation Instructions Manual pdf 37 page image

General informationMoving your applianceYou may damage some soft or badly fitted floor coverings when youmove the appliance. The floor covering under the appliance should besecurely fixed so it does not ruck up when you move the applianceacross it. Alternatively you could remove the floor covering.To move the appliance open the second oven door. Raise theappliance off its front feet by lifting it from inside the oven. Pull theappliance forward. When you replace the appliance push it back to thestop and make sure there is the same gap at each rear corner.Connecting to the electricity supplyThe plug supplied with the appliance can be fitted directly to a suitablethree pin earthed socket. Ensure the plug is accessible to the user.If you have to change the fuse replace it with a 3 amp fuse which hasbeen ASTA approved to BS 1362.Do not use the plug until you have put the fuse cover back on. If thefuse cover is lost you can get a replacement from an electrical retailer.The correct replacement can be identified by marking or colour coding.If you cut the plug off dispose of it safely as it will be a shock hazardif it is inserted into a 13 amp socket elsewhere in the house.37S G 4 5 4General informationFor your safetyDo not try to disconnect the appliance from the gas supply if thesupply pipe does not have a bayonet connection, as described inthe installation instructions. If this is the case contact the personwho installed the appliance.For your safetyThis appliance must be earthed and protected by a 3 amp fuse.For your safetyDo not block any of the appliance vents.Never line any part of the appliance with foil.Do not let items which can catch fire or electric mains leads suchas kettle flexes trail over any part of the appliance.