Panduit CT-1700 Operating Instructions Manual

Contents

operation instructions

Panduit CT-1700 Operating Instructions Manual Manual pdf 1 page image

Part No. CT-1700OPERATION INSTRUCTIONSContour CrimpCONTROLLED CYCLECRIMPING TOOLCrimps Panduit #8 - #1 AWGcopper lugs and splices, #6 - #4AWG aluminum lugs and splices,#8 - #2 AWG non-insulated S seriestubular terminals; and #16 AWG -#3 AWG copper CTAPF taps.Provides UL Listed and CSA Certified terminationswith applicable Panduit terminals.COPPER AND ALUMINUM COMPRESSIONCONNECTOR CRIMPING INSTRUCTIONSOPERATION INSTRUCTIONSPA23614A01Rev.: 04 9-2015CT-1700Figure 11. With the handles in the open position,depress die release and rotate die to desiredpocket. The pocket will lock in place when anaudible “click” is heard (Die index number andcolor appear to the left of correspondingpocket).CAUTION: Do not cycle tool unless the dierelease button has seated and the die haslocked in place.Refer to product packaging for selection of theproper crimp pocket. Place the desiredcompression connector in the crimp pocket(See Fig. 2).2. Close handles until the connector is heldsnugly in position—do not deform the barrel.3. Remove end plug(s) [for aluminumcompression connectors only]. Insert thestripped wire into the connector until the wirestops. Refer to product packaging for wire striplength.4. Crimp the connector by closing the handlesuntil the controlled cycle mechanism releases.Repeat this operation for the compressionconnectors that require more than onecompression.Upon release, the handles will openautomatically and the crimped connector canbe removed.After crimping, inspect that the crimp iscentered on the barrel in order to achieveoptimal pullout performance. Also, inspect dieindex number embossed in connector by crimpdie.© Panduit Corp. 2015Email:techsupport@panduit.comEU Website: www.panduit.com/emeaEU Email: emeatoolservicecenter@panduit.comTechnical SupportTel: 1-800-777-3300Panduit Europe • EMEA Service CenterTel: +31 546 580 452 • Fax: +31 546 580 441CAUTION: Verify power is “OFF” beforeworking on wiring with this tool. Thecushioned grips are for the user’scomfort, and are not intended to insulateagainst shock while working on liveelectrical circuits.Page: 1 of 2Rotating CrimpDie WheelCrimp Die Release Push ButtonFigure 2DIE INDEX NUMBEREMBOSSED FORINSPECTIONwww.panduit.comCRIMP POCKETS FORPanduit CompressionConnectors. Refer to productpackaging for wire range andproper crimp pocket. Crimppockets are identified withapplicable die index numberand color code.Controlled cycle mechanismprevents tool from openingbefore crimp cycle iscomplete.Manual release lever, pushforward in the event thatcontrolled cycle mechanismmust be released.Cushioned Handle Grips

/ 2

Related manuals for Panduit CT-1700