Menu
Panasonic Z-421V Technical Manual
                                               | |
Contents
|
3DQDVRQLF16ident stage of the Automatic System Manager (IDS signal). The H/2 switch distributes thedemodulated signal to the (R-Y) and (B-Y) amplifiers and via the PAL/SECAM switch (PS) to thebaseband delay line. The bypass mode of the delay line is not possible for SECAM.The VINT and U INT signals from delay line outputs are fed to the YUV selection circuit (see YUV/RGBprocessing part).* ASM ( Automatic System Manager )The ASM is field synchronous; it can identify PAL/NTSC/SECAM color standards. The differentpossibilities are controlled by the I²C bus input commands (CM2 --> CM0) . These input commandsare communicated to the ASM via the I²C bus.The I²C bus input commands (XA, XB) , also supplied to the ASM via the I²C bus, indicate which Xtalsmust be connected to pins 34 and 35. This is essential for correct calibration of the horizontaloscillator.The I2C command FCO disables the color killer in forced modes only and allows maximum colorsensitivity. (see also I²C bus description).For color identification purposes there is also communication with the ASM and:- the PAL/NTSC ident circuits (IDP, IDN)- the SECAM ident (IDS)- the VCXO via xtalswitch (XTS)- the PAL/SECAM switch (PS)- the R-Y demodulator (H/2)The I²C output commands (SXA, SXB) indicate whether the (XA, XB) bits have been correctlytransmitted by the I²C bus. The I²C output commands (CD2 --> CD0) indicate which color system hasbeen identified.* The (B-Y)/(R-Y) demodulationThe (B-Y)/(R-Y) baseband signals are extracted from the chroma signal by the (B-Y)/(R-Y)demodulators, filtered and supplied via the output switch to pins 29 and 30 respectively. For correctdemodulation of (R-Y) PAL signals, then the demodulated (R-Y) signals requires 180" phase reversalon alternate lines, this is realized with the PAL switchThe demodulator gain ratio (B-Y)/(R-Y) is typically 1.78 in order to compensate far scaling in thetransmitter. During the line/field blanking periods of the sandcastle pulse the (B-Y)/(R-Y) are blocked ;then the correct DC levels are supplied to the (B-Y)/(R-Y) outputs.When SECAM is identified by the SECAM add-on decoder and no PAL/NTSC is already identified bythe ASM, then the ASM sets the (B-Y)/(R-Y) switch open via (DEMSW). This implies that the (B-Y)/(R-Y) signals from the SECAM decoder can be directly connected to pin 29 and 30 respectively withoutextra loading. |
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved