13 Configure the alarm settings [Alarm]The settings relating to alarm occurrences such as settings for the alarm action at an alarm occurrence, theVMD area settings, and the alarm occurrence notification can be configured on this page.The “Alarm” page has 3 tabs; the [Alarm] tab, the [VMD area] tab and the [Notification] tab.13.1 Configure the settings relating to the alarmaction [Alarm]Click the [Alarm] tab on the “Alarm” page. (®page 46, page 48)The settings relating to the alarm can be configured in this section. Refer to page 115 and page 118 for furtherinformation about the settings relating to the alarm images and the alarm output terminal.Alarm[Terminal 1]Determine how to use terminal 1.• Off: Not used.• Alarm input: Receives alarms. When “Alarm input” is selected, a pull-down menu for “Close” and“Open” is displayed.– Close: An alarm is detected when the terminal status is changed to “Close”.– Open: An alarm is detected when the terminal status is changed to “Open”.• Black & white inputSW559SW559SP509SP509SF549SF549SF539SF539 : Receives the black & white switchover input.(When the input is set to On, the black & white mode is activated.)• Default: Off[Terminal 2]Determine how to use terminal 2.• Off: Not used.• Alarm inputSW559SW559SP509SP509SF549SF549SF539SF539 : Receives alarms. When “Alarm input” is selected, apull-down menu for “Close” and “Open” is displayed.– Close: An alarm is detected when the terminal status is changed to “Close”.– Open: An alarm is detected when the terminal status is changed to “Open”.• Alarm output: Alarm output will be carried out according to the settings for “Alarm output terminalsetup” (®page 118).114 Operating Instructions13 Configure the alarm settings [Alarm]
