• Default: Auto1(Normal)Note• The operating sound might be heard when changing to black-and-white mode, however it does notindicate any malfunction.[Day & Night(electrical)]SW558SW558SP508SP508SF548SF548SF538SF538Select switching between the color mode and the black & white mode from the following.• Off: The color mode is selected.• Auto: Switches from color to black-and-white images when the ambient brightness (illuminance) of thecamera is approx. 1.0 lx or less. It takes time to switch between modes.• Default: Off[Level]SW559SW559SP509SP509SF549SF549SF539SF539Select the threshold illuminance level (brightness) to switch between the color mode and the black & whitemode.The descriptions about the following threshold illuminance levels are given when “Off” is selected for “SuperDynamic(SD)”.• High: Switches from the color mode to the black & white mode when the ambient brightness (illuminance)of the camera is approx. 6 lx or less.• Low: Switches from the color mode to the black & white mode when the ambient brightness (illuminance)of the camera is approx. 2 lx or less.• Default: High[Dwell time]SW559SW559SP509SP509SF549SF549SF539SF539Select a wait time for switching between the color mode and the black & white mode from the following.2s/ 10s/ 30s/ 1min• Default: 10s[White balance]Select a method of white balance adjustment from the following.White color can be adjusted by “Red gain” and “Blue gain”.• ATW1: Selects the automatic tracing white balance mode. The camera will constantly check the colortemperature of the light source and adjust the white balance automatically. Operating color temperaturerange is approx. 2,700 K to 6,000 K.• ATW2: Selects the automatic tracing white balance mode under a sodium lamp. The camera will adjustthe white balance automatically under a sodium lamp. Operating color temperature range is approx. 2,000K to 6,000 K.• AWC: Selects the automatic white balance control mode. This adjustment is suitable for a location wherea light source is stable. Operating color temperature range is approx. 2,000 K to 10,000 K.• Default: ATW1Note• Under the following conditions, color may not be faithfully processed. In these cases, select “AWC”.– When shooting a subject whose major part is a thick color– When shooting blue sky or sun at sunset– When shooting a subject whose luminance is too low• When “AWC” is selected, click the [Set] button.[Red gain]Adjust the red color of images.When the cursor is moved in the “+” direction, the red color will become thicker. When the cursor is moved inthe “-” direction, the red color will be thinner. Click the [Reset] button to reset the color to the default.96 Operating Instructions11 Configure the settings relating to images and audio [Image/Audio]
