Panasonic WV-SW316L Installation Manual

Also see for WV-SW314: Integration note Product catalog Specification

Panasonic WV-SW316L Installation Manual Manual pdf 29 page image

29z Be sure to view the monitor for adjustment when the camera angle is adjusted.Supply power to this unit, connect the monitor for adjustment (e.g. a small LCD) to the monitoroutput jack, and adjust the camera angle (turn off the power after view angle adjustment for safety).q Loosen the 4 fixing screws of the front cover to remove the front cover.w Connect the monitor output jack and the monitor for adjustment with the RCA pin cable(locally procured). (This illustration represents WV-SW316.)e Repeat the steps (1) and (2) to adjust the camera angle.(1) Loosen the panning lock screw and rotate the camera head horizontally to adjust panning.(2) Loosen the tilting lock screw and rotate the camera head vertically to adjust tilting.(3) Tighten the panning lock screw and tilting lock screw after camera angle adjustment.IMPORTANT:• After camera angle adjustment, the panning lock screw and tilting lock screw shall be securely tightened.Recommended tightening torque: 2.45 N·m {1.8 lbf·ft}Tilting lock screwPanning lock screwNotes:• Use a hexagonal wrench with width across flats of 4 mm (locally procured) to loosen or tightenthe panning lock screw and tilting lock screw.• Approximately 1 rotation of loosening the panning lock screw and tilting lock screw allows cam-era angle adjustment. Do not loosen the screws beyond necessity.• The camera body shall be held when the panning lock screw or tilting lock screw is loosened.• Focus adjustment (☞ page 30-32) shall be performed at the same time panning and tiltingadjustments are performed.AdjustmentFixing screw x4Front coverMonitor output jack