Panasonic WV-SF330 Series Installation Manual

Also see for i-Pro WV-SF332: Product catalog Integration note Specifications Installation guide Product catalog

Panasonic WV-SF330 Series Installation Manual Manual pdf 21 page image

21PreparationsWhen installing the camera on a wall or a ceiling, there are four methods as specified below.(☞ Pages 22 and 23)• Using the two-gang junction box• Installing the camera directly on the ceiling or wall• Using the ceiling mount bracket WV-Q174 (option) (for embedded installation on a ceiling)SF336 SF335 SF332• Using the ceiling mount bracket WV-Q105*1 (option) (for direct mounting on a ceiling)Important:• Procure 4 screws (M4) to secure the camera to a wall or a ceiling according to the material ofthe installation area. In this case, wood screws and nails should not be used. For mounting acamera on a concrete wall, use an anchor bolt (for M4) or an AY plug bolt (M4) for securing.(Recommended tightening torque: 1.6 N·m {1.18 lbf·ft})• Required pull-out capacity of a single screw/bolt is 196 N {44 lbf} or more.• If a ceiling board such as plaster board is too weak to support the total weight, the area shallbe sufficiently reinforced or the ceiling mount bracket for the camera, WV-Q105 (option), mustbe used.The mounting conditions of the camera are described as follows:InstallationplaceApplicable mountbracketRecommendedscrewNumber ofscrewMinimum pull-outstrength (per 1 pc.)Ceiling/wall Two-gang junctionboxM4 4 pcs. 196 N {44 lbf}Ceiling/wall (Direct mounting) M4 4 pcs. 196 N {44 lbf}SF336 SF335 SF332Ceiling WV-Q174 (approx.280 g {0.62 lbs})– – * 2Ceiling WV-Q105* 1 (approx.150 g {0.33 lbs})– – * 2*1 PAL models only*2 Make sure that the installed mount bracket can support more than 5 times of the weight of thecamera.