PREFACEThe Panasonic Ceiling Mount Bracket WV-Q116 is provided for the surface mounting of theCombination Camera WV-CS954 on a suspended (double) ceiling.Instructions Model No. WV-Q116Ceiling Mount BracketBefore attempting to connect or operate this product, please read these instructions completely.PRECAUTIONS• Before installing the camera, make sure that thelocation where the camera is going to be installedis strong enough to support the entire weight ofthe camera (approximately 2.9 kg {6.38 lbs}).• Mount this bracket in a suspended ceiling havinga minimum of 210 mm {8-9/32”} clearance.• The ceiling board thickness to mount this brack-et can be a maximum of 40 mm {1-37/64”} inthickness.• Be sure to use the Fall Prevention Wire (provided).• Be sure to lock the camera with the lock plate,and make sure that it cannot come off.• Do not use this bracket with any equipment otherthan the WV-CS954.• Follow all applicable local and national electrical,fire and safety codes when installing the camerawith this ceiling mount bracket.Minimum inside ceilingclearance 210 mm {8-9/32”}Suspendedceiling Maximum 40 mm{1-37/64”}The model numbers listed in these Instructions have no suffixes attached to them.*Refer to the camera’s operation manual.Inside the ceilingSuspended ceilingCamera Mounting BaseFall Prevention Angle ClipFall Prevention Wire(provided)Combination cameraINSTLLATIONBe sure to read the "Precautions" before installing the camera.WV-Q116E_E.qxd 05.2.2 11:05 Page 1