Panasonic WV-NP1004 Network Operating Instructions

Also see for WVNP1000 - NETWORK CAMERA: Integration note Operating instructions Manual Operating instructions

Contents

Panasonic WV-NP1004 Network Operating Instructions Manual pdf 54 page image

54How to adjust white balance(When "AWC" is selected "WHITE BAL")q Select "AWC" for "WHITE BAL", and then pressthe [Left] button to switch to "AWC→PUSH SW".w Press the [SET] button to adjust white balance.The "PUSH SW" part will be highlighted in theprocess of the adjustment. When the highlightedindication returns to normal indication, adjust-ment of white balance is complete.e Press the [Right] button to select "AWC".Refer to page 61 for descriptions of how to adjustwhite balance finely.Note:Operating color temperature range is approx.2 000 K – 10 000 K. When white balance is out ofoperating range or illuminance of subject is too low,white balance adjustment may not be complete.In this case, the "PUSH SW" part remains beinghighlighted.[DNR]When this function (digital noise reduction) is active,noise may be automatically reduced under a low illumi-nance. Select an effect level "LOW" or "HIGH" for thedigital noise reduction.LOW: Low level of noise reduction effectHIGH: High level of noise reduction effectDefault: HIGH[BW MODE]Configure the settings relating to the B/W mode.Refer to page 62 for descriptions of how to configure theB/W mode setting.[PRIVACY ZONE]When there is a zone that is not to be displayed, set thezone as a privacy zone to not to display.Up to 8 privacy zones can be set and the following areavailable to identify them on the screen.ON (1): Display in gray colorON (2): Display in mosaicOFF: Display without effect for identification purposeRefer to page 63 for descriptions of how to set privacyzones.Default: OFFNote:Privacy zones will not function just in the process ofinitialization just after turning the power on.[EL-ZOOM]Select "ON" or "OFF" to determine whether or not to usethe electronic zoom.ON: Use the electronic zoom. Images can be enlargedup to fivefold (x5).Refer to page 64 for descriptions of how to adjustthe electronic zoom.OFF: Does not use the electronic zoom.Default: OFF[STABILIZER]Select "ON" or "OFF" to determine whether or not to usethe image stabilizer to prevent shaky images. It is effec-tive to use this function when the camera is installed ona pole, etc.ON: Image shake will be stabilized.OFF: Image shake will not be stabilized.Default: OFFImportant:• When "ON" is selected, the angular field of view willbecome narrower and the image resolution will becoarse. When "ON" is selected, install the camerawhile checking the angular field of view and the res-olution.• The image stabilizer may sometimes not function forthe following subject.• Dark subject• A subject whose brightness difference is almostnone (white wall, etc.)• A subject that vibrates at high pitch such asmechanical vibration• A subject whose vibration amplitude is large