39Configure the settings of the servers [Server setup]The settings relating to the mail server and the FTP server can be configured on this page.The "Server setup" page has 2 tabs of the [Mail] tab and the [FTP] tab.Configure the settings relating to the mail server [Mail]Click the [Mail] tab on the "Server setup" page.The settings relating to the mail server used to send the alarm mail can be configured on this page.[SMTP server address]*Enter the IP address or the host name of the SMTPserver used to send e-mails.Number of characters for the SMTP server address:1 - 128 characters[POP server address]*When "POP before SMTP" is selected for"Authentication", enter the IP address or the host nameof the POP server.Number of characters for the POP server address:1 - 128 characters* Important:When entering the host name for "POP serveraddress", it is necessary to configure the DNS set-tings on the [Network] tab of the "Network setup"page. (☞ page 42)[Authentication]Select the authentication method to send e-mails fromthe following.None: It is unnecessary to clear any authentication tosend e-mails.POP before SMTP: It is necessary to clear the POPserver authentication first to use the SMTP server tosend e-mails.SMTP: It is necessary to clear the SMTP server authen-tication to send e-mails.Default: NoneNote:When you don’t know the authentication method tosend e-mails, refer to the network administrator.[User name]Enter the user name to access the server.Number of characters for the user name: 1 - 32 char-acters[Password]Enter the password to access the server.Number of characters for the password: 0 - 32 char-acters[Sender mail address]Enter the mail address of a sender.Entered mail address will be displayed in the "From"(sender) line of the sent mails.Number of characters for the sender address:3 - 128 characters