Panasonic WV-NF284E Installation Manual

Also see for WV-NF284E: Network operating instructions

Contents

Panasonic WV-NF284E Installation Manual Manual pdf 14 page image

14 Inside the dome coverq LEDs (Indicators)• Access indicator (green)Blinks when the camera is accessed.• Link indicator (orange)Lights when the communication with anetwork is established.• SD memory card error indicator (red)Lights when an error occurred in the SDmemory card.w Indicators ON/OFF switchSelect "ON" or "OFF" to determinewhether or not to activate the link indica-tor and the access indicator.Important:Select "ON" for normal use.When "ON" is selected, it is possible toturn on/off this switch using a PC via anetwork.When it is necessary to turn off the indi-cators, turn off the indicators using a PCvia a network (by selecting "OFF" for"Link/Access LED" of "Basic Setup" onthe setup menu).(Refer to the network operating instruc-tions (PDF) for further information.)e Monitor out connector (for adjustment)(ø3.5mm mini jack)This connector is provided only forchecking the adjustment the angular fieldof view or the focus on the video monitorwhen installing the camera or when serv-icing. ( page 21)r Image tilt adjustment ringUse this ring to correct image tilt.( page 26)t SD memory card slotInsert an SD memory card. ( page 28)y Zoom ringUse this ring to adjust the angular field ofview. ( page 27)u Focus ringUse this ring to adjust the focus.( page 27)i Tilting tableRotate this table to adjust the tilting angleof the camera. ( page 26)o Panning table fixing screw [LOCK]Fix the panning table with this screw afteradjusting the panning angle of the cam-era. ( page 26)!0 Panning tableRotate this table to adjust the panningangle of the camera. ( page 26) Dome coverProtect the camera head with this domecover.!1 Dome cover lock marker( pages 18 - 20)!2 Microphone holeThis hole is for microphone input (audiocapture). Do not block this hole.Otherwise, audio may become garbled.!3 Inner dome!4 Clear domeRemove the cover film from the domecover after the installation is complete.Do not touch the dome cover by handdirectly after removing the cover film. Mounting side!7 External I/O terminalsConnect an external device to these ter-minals. ( page 22)!8 Power cord terminalsConnect the power cord from a DC12 Vor an AC 24 V power supply.( page 21)