9[Precautions for use]This product has no power switch.Turn the power off when cleaning the product.To keep on using with stable performanceParts of this product may deteriorate and itmay shorten the lifetime of this product whenusing in locations subject to high temperaturesand high humidity. (Recommended operatingtemperature: +35 °C or lower)Do not expose this product to direct heatsources such as a heater.Handle this product with care.Do not abuse this product. Avoid striking,shaking, etc. The product could be damagedby improper handling or storage. If a strongshock or vibration is applied to the enclosure, itmay cause damage or allow water to enter thisproduct.Do not touch the dome cover with yourbare hands.A dirty dome cover causes deterioration of pic-ture quality.Discoloration on the CCD color filterWhen continuously shooting a bright lightsource such as a spotlight, the color filter ofthe CCD may have deteriorated and it maycause discoloration. Even when changing thefixed shooting direction after continuouslyshooting a spotlight for a certain period, thediscoloration may remain.Do not aim this product at strong lightsources.A light source such as a spot light causes ablooming (light bleeding) or a smear (verticallines).Cleaning this product bodyTurn the power off when cleaning the product.Do not use strong abrasive detergent whencleaning this product. Otherwise, it may causediscoloration. When using a chemical cloth forcleaning, read the caution provided with thechemical cloth product.To remove stubborn stainsWhen the dirt is hard to remove, use a milddetergent and wipe gently. Then, wipe off theremaining detergent with a dry cloth.What to do if OVER HEAT appears on thedisplayThis message indicates that the inside of thecamera has become extremely hot. Immediate-ly turn off the power of the camera and contactyour dealer.About the dehumidifying device• This product has dehumidifying device tokeep the inside at low moisture level, pre-venting condensation.• Dew may be produced depending on theconditions of temperature, humidity, winds,and rain, and it may take time to dehumidi-fy.• Never seal the surfaces of the dehumidify-ing device.Dehumidifying deviceSmear Blight subjectBlooming