Panasonic WJ-RT208 Operating Instructions Manual

Also see for WJRT208 - Digital Disk Recorder: Reference

Panasonic WJ-RT208 Operating Instructions Manual Manual pdf 34 page image

Descriptions and remarks Selectable parameters[Default Setting]Item"Full, 1/2F, 1/4F, 1/8F, 1/16F""Full"Note: When "Terminal Input" is set at "N.C.", an alarm unit of "N.O." should be connected to the alarm port of this unit. If no con-nections are made, the alarm port will be "N.O." (normally open) and will continue receiving alarm signals at all times."Pre Recording""Rec. Quality""I Frame Inter.""Resolution""Alarm Spot""Stream Type""Terminal Input""Frame Rate"The time period for pre recording can differ according to the order ofrecording start. The minimum time period is 5 seconds. (Changeable with"I Frame Inter.", "Rec. Quality", and "Stream Type")When changing this setting, it is necessary to stop recording and discon-nect all network connections.Note: When Pre Recording is set at "On", the pre-recorded image datamay be separated to different data groups.If settings of "Rec. Quality", "I Frame Inter.", "Stream Type", and "FrameRate" are changed in the middle of recording, recording will stop andthen will resume. Then the setting values become effective.If recording is not stopped, the new setting becomes effective after thelapse of the time period preset with "RECORD LENGTH".Playback is delayed if the setting value for "I Frame Inter." is too high. Werecommended using a default value. When changing this setting, it isnecessary to stop recording and disconnect the network connections.Implement the settings of "I Frame Inter." after the pre-recording settinghas been set at OFF.Resolution of image data output from the VGA interfaceWhen an alarm goes off, the screen of the occurring alarm is displayed inthe single-spot mode.When the setting is made at "VBR", there may be a difference in recordinglength. If the recording time need be in higher preference, the settingshould be made at "CBR". If screen changes seem to be extreme, the set-ting made at "VBR" is preferable.N.O.: Alarm is started with a low-level signal.N.C.: Alarm is started with a high-level signal.The frame rate set at "Full" is 25 frames/second."On/Off" "Off""SP Fine/Fine/Good/Normal/Extended""Normal"01 - 1504800 x 600 or 1024 x 768[800 x 600]On/Off "Off"CBR/VBR"CBR"N.O./N.C."N.O."34System setup (SYSTEM SETUP)"Power On Rec." Recording will automatically start when the power is turned on. "On/Off""Off""Seq. Dwell" Sequential changeover time intervals. 02 - 30, 05"Video Format""Overwrite""Status Display""Keylock Time""Keylock Buzz""Alarm Buzz"The video output format is fixed to the NTSC system. Therefore, the usercannot set the settings.Even when "On" is selected for "Overwrite", recording will not be per-formed to protect data from overwriting for the days set on "Rec. Reserve"of "CAMERA SETUP" unless the set days have passed.It is possible to conceal information such as the channel name that is dis-played on the screen.Even after the lapse of the preset time, the key lock does not function ifrecording data is being backed up.After the lapse of the preset time counted after the completion of record-ing data backup, the key will be automatically locked.When setting is made at "On" and a password is wrongly keyed in threetimes continuously, the buzzer begins to sound for one minute.Buzzer "On/Off" is set up."NTSC""On/Off""On""All/Stat/None/Name""All"005 - 999 600"On/Off" "On""On/Off" "Off"