31(4) After completing the settings, press the [MENU] buttonagain to close the camera setup menu.Caution: When displaying the Special Menu, move thecursor to "SPECIAL" on the camera setup menu andpress the camera selection button [2].When returning the camera settings to the defaultsettings, move the cursor to "CAMERA RESET" andpress the camera selection button [3].Press the [ESC] button to move from the Specialmenu back to the previous menu.2.6 Control this Unit with a PCWhen this unit is connected to a network, it is possible tooperate and set up this unit with the software on the acces-sory disc.In this case, outlined explanations will be given about thefunctions available and requirements for the computer con-figuration.For details about each function, refer to the NetworkOperating Instructions on the accessory disc.2.6.1 Outlined functions• Display of live monitoring screen and recording• Playback and downloading of the recorded data• Setup of this unit• Event notification (Alarm)• Automatic time and date adjustment2.6.2 Computer configurationA computer with the configuration specified below is rec-ommended. If a computer other than the recommendedone is used, some problems may arise including softwarenot starting, delayed screen display, and operation failures.Notes:* If the Graphic Memory is not over 32 MB, only a maxi-mum of four channels can be connected to theNetClient.* The NetClient cannot be started unless the display driv-er overlay is applied.* For some display driver versions, the NetClient may failto start normally. In this case, update the display driverto the latest version.OSPCCPUMainMemoryGraphicMemoryDisplayDriverInterfaceMonitorOthersMicrosoft Windows 2000 Professional SP4Microsoft Windows XP Professional or EditionSP2IBM PC/AT CompatibleIntel Pentium 4, 2.4 GHz or fasterDDR 512 MBIndependent larger than 64 MBOverlay supported100 MB network interface card built-inResolution: better than 1024 x 768,24 bit true colorDirect X 8.0a or later