Panasonic WJ-RT208 Operating Instructions Manual

Also see for WJRT208 - Digital Disk Recorder: Reference

Panasonic WJ-RT208 Operating Instructions Manual Manual pdf 25 page image

25Note: If time is corrected in the middle of recording,part of the recorded data may fail to be played. Thisis because some turbulence can arise in the recordstart time and the end time.1.5 Turning the Power OffThe power supply for this unit cannot be turned off if harddisk data are being played or data are being recorded onthe hard disk. Operation for playback or recording has tobe stopped first. Turn off the power supply after confirmingthat the HDD indicator of the front panel is not lit.(1) Stop the manual recording.• Select the desired image to be stopped by using thecamera selection button (1 - 8) or the direction button(up/down).Hold down the [STOP] button for 2 seconds.The Record indicator of the numerical keys goes offand recording is stopped.• For timer recording, alarm recording, or motion detectorrecording, set up "On" or "Off" for each one with "WJ-RT208 SETUP MENU" – "REC&EVENT SETUP", and thenstop recording in the above procedures.(2) Stop playback.• Select channel 1 by using the camera selection button(1 - 8) or the direction button (up/down), and press the[STOP] button. Playback is stopped.(3) Turn off the power switch on the rear panel.• Turn off the power supply after confirming that the HDDindicator of the front panel is not lit.• Check the [OPERATE] indicator. If this indicator is notlit, the power supply has been turned off.Note: If this unit is not used for a long time, pull out thepower cord from the power connector.1.4 Modification of the System TimeWhen this unit is used for the first time, set up the systemtime with the procedures specified below. This system timeshould be checked periodically. If it seems to be incorrect,readjustments are needed.(1) Click the [MENU] button to display the setting menu.(2) Move the cursor to "SYSTEM MANAGEMENT" andpress the [SET] button.The "SYSTEM MANAGEMENT" menu appears.(3) Move the cursor to "TIME & DATE" and press the [SET]button."TIME & DATE" menu appears.Move the cursor to the correcting position.(4) Enter the local time by using Buttons [0] - [9].(5) Move the cursor to [OK] and press the [SET] button.(6) End of settingWhen the [ESC] button is pressed several times, thescreen returns to the previous menu "SYSTEM MAN-AGEMENT".WJ-RT208 SETUP MENUSYSTEM MANAGEMENTSEARCHREC&EVENT SETUPPTZ SETUPCAMERA SETUPCOMMUNICATION SETUPREPORTUSER INFORMATIONDATA MANAGEMENTOK2005-01-28 10:43:38TIME & DATEYYYY-MM-DD HH:MM:SSCancelSYSTEM MANAGEMENTSYSTEM SETUPDISK INFORMATIONREBOOT SYSTEMPICTURE ADJUSTTIME & DATEVERSION