Panasonic WJ-RT208 Operating Instructions Manual

Also see for WJRT208 - Digital Disk Recorder: Reference

Panasonic WJ-RT208 Operating Instructions Manual Manual pdf 18 page image

• Connection with PS·Data systemsThis is an example of connection when the unit is used together with the PS·Data devices.If a connected system controller is PS·Data compatible, it is possible to operate this unit or connected devices using the sys-tem controller.Use the RS485 cable provided with the system controller.Important:• Terminate both devices on both ends of the connection. Refer to the respective operating instructions for the descriptionsof how to terminate. Termination of this unit can be set with the DIP termination switch on the rear panel. (See page 21.)• When connecting a PS·Data compatible device, it is necessary to set each item of "DATA PORT SETUP" of "COMMUNICA-TION SETUP" on the "WJ-RT208 SETUP MENU" according to the system configuration.• The following are available PS·Data compatible devices.• System controller: WV-CU650• Matrix switcher: WJ-SX150• Data multiplex unit: WJ-MP204(Any other PS·Data compatible devices are not to be connected.)When connecting a single unit with a controllerMODE DATA 10/100BASE-T COPY1 SERIAL MONITOR(VGA)TERMINAL/CONTROLAUDIO OUTVIDEO OUTAC INSIGNAL GNDPOWER 1122334455667788ONOFFVIDEO INAUDIO INThis unit1ON2Mode switchA B1 324 657 980SYSTEM CONTROLLERControllerTermination: ONUnit address: 1RS485 cable(provided with the controller)MODE DATA 10/100BASE-T COPY1 SERIAL MONITOR(VGA)TERMINAL/CONTROLAUDIO OUTVIDEO OUTAC INSIGNAL GNDPOWER 1122334455667788ONOFFVIDEO INAUDIO INMODE DATA 10/100BASE-T COPY1 SERIAL MONITOR(VGA)TERMINAL/CONTROLAUDIO OUTVIDEO OUTAC INSIGNAL GNDPOWER 1122334455667788ONOFFVIDEO INAUDIO INMODE DATA 10/100BASE-T COPY1 SERIAL MONITOR(VGA)TERMINAL/CONTROLAUDIO OUTVIDEO OUTAC INSIGNAL GNDPOWER 1122334455667788ONOFFVIDEO INAUDIO INA B1 324 657 980SYSTEM CONTROLLERControllerTermination: ONUnit address: 11ON2Mode switch1ON2Mode switchRS485 cable(provided with the controller)RS485 cableRS485 cableRS485 cableRS485 cable1st unit (this unit)Unit address(system): 12nd unit (this unit)Unit address(system): 23rd unit (this unit)Unit address(system): 31ON2Mode switchWhen connecting multiple units with a controller"WJ-RT208 SETUP MENU" → "COMMUNICA-TION SETUP" → "DATA PORT SETUP" → "UnitAddress (System)": 118