Panasonic WJ-RT208 Operating Instructions Manual

Also see for WJRT208 - Digital Disk Recorder: Reference

Panasonic WJ-RT208 Operating Instructions Manual Manual pdf 12 page image

124. Ready the hard disk and install wire jumpers.To connect two hard disks to one IDE interface, make sure to designate one as the Master HDD and the other the SlaveHDD. If only one hard disk is connected, make this the Master HDD. (For connection of the Master and Slave HDD, refer tothe operating instructions of the hard disk.)Pay attention to the following when choosing the connection position of the Master and Slave HDD.(1) When connecting two hard disks to IDE port 1, make the one on the left the Master and the one on the right the Slave,as seen from the front of the recorder. See Fig. 3.(2) When connecting three pairs of hard disks to IDE port 0, 2 and 3 (6 in total), make the top one the Master and the bot-tom one the Slave (see Figs. 3 and 5).Note: Port 0 was installed to the two disks installed model. Port 0 and 1 were installed to the four disks installed model.(For the relation between hard disk positions refer to the figure above or the explanation on hard disk management onpage 47.)5. Insert the hard disk into the hard disk fixing frame.Fix it with four screws at the side of the frame. (Fig. 4, 5)6. Insert the hard disk fixing frame in the proper location inside the recorder and fix it with a screw (Fig. 6). (Be careful not todamage the fan connection terminal and hard disk cable.)Fig. 6 Fig. 7Fig. 3Master HDD ofIDE port 1Slave HDD ofIDE port 1HDD connectedto IDE port 3HDD connectedto IDE port 2HDD connectedto IDE port 0Fig. 4 Fig. 5Master HDDSlave HDD