Panasonic WJ-ND300A Setup Instructions

Also see for WJ-ND300A: Brochure Reference Manual Operating instructions Operating instructions

Contents

Panasonic WJ-ND300A Setup Instructions Manual pdf 32 page image

32Setup items REC TypeSelect "QUICK" or "ADVANCED" for validation of the recording settings.QUICK: The recording settings set on the setup menu (Quick) will be validated when recording.ADVANCED: The recording settings set on the setup menu (Advanced) will be validated when recording.It is possible to check if the set recording rate and transmission rate are available for the network in use by clickingthe [Measurement] button. It will take around 90 seconds to check. In the process of measurement, recording andcopying will stop.When the set rate is displayed red, recording/transmission may be failed with the set rate.Notes:• When "QUICK" is selected, the setup menu (Quick) will be displayed by clicking the [Setup] tab. When"ADVANCED" is selected, the setup menu (Advanced) will be displayed by clicking the [Setup] tab.• When "QUICK" is selected, the following setup items of "Schedule" (Advanced) will not function. When it is nec-essary to function the following items, select "ADVANCED".* To perform the schedule recording, perform the settings for "Time Table" and "Program".• When "QUICK" is selected, MPEG-4 live image will not be displayed and recording will not be performed.SubmenuTime TableSetup items Status"FTP SEND BY PERIODIC TIMER" Disabled"WARNING REPORT MAIL" Disabled"FTP ALARM SENDING" Disabled"ALARM MESSAGE" Functions normally (Fixed to "ON".)"Panasonic Alarm Protocol" Disabled"ALARM MAIL" DisabledProgramSpecial DaysProgram 1 - 4 The settings performed on the setup menu(Advanced) will not be validated.The settings performed on the setup menu(Quick) will be validated. *DisabledCheck if the result value (total value of the maximum network speed of each camera) is below the maximum networkspeed of the unit (50 Mbps as indication).When the result value is beyond the maximum network speed of the unit (50 Mbps as indication)(Example: 50 Mbps < 60 Mbps (result value))When the result value is beyond the maximum network speed of the unit (50 Mbps as indication), refer each rate for"LIVE VIDEO", "MANUAL REC", "SCHEDULE REC" and "EVENT REC". Then, lower the higher rate among them orlower image quality to diminish the network traffic from the camera. Click the [Measurement] button to check if theresult value is below the maximum network speed. Repeat this procedure until the result value becomes less than50 Mbps (as indication).