Panasonic WE-MV180A Service Manual

Also see for WEMV180A - VIDEO IMAGER: Operating instructions Operating instructions

2r Zoom Buttons (ZOOM, IN/OUT)These buttons are used to zoom in or out from theobject.t LensThe close-up lens and lens cap are attached to the lens.When you use this appliance, detach the lens cap.When the distance between the lens and the object tobe shot is more than 2 meters (6.6 ft), detach the close-up lens by rotating it counterclockwise.y Arm LightThis light is used to illuminate objects in a dark environ-ment.u Stage (with back light)Place objects here.The stage is lit by turning the backlight on. Place trans-parencies or film here to project them on a video moni-tor.i LCD MonitorThe visual image of the document on the stage is pro-jected on this liquid crystal display monitor.• Brightness Control (BRIGHT, BRT/DARK)This dial is used to control the brightness of the monitor.Rotate the dial to the left to make the image brighter orto the right to make it darker.o Camera Arm!0 Light Selector(ARM LIGHT ON, OFF, BACK LIGHT ON)This selector is used to turn the arm light or the backlighton and off.!1 White Balance Button (WHITE BALANCE)This button is used to set the white balance when shoot-ing a transparency or a film with the arm light or back-light.Press this button. It takes about two seconds for theauto white balance function to adjust the white balanceproperly.Note:Press this button to shoot negative film, or positivefilm after shooting negative film.!2 Frame Memory Button (FRAME MEMORY)This button is used to memorize the document on thestage (frame memory function). Before changing thedocument on the stage, press this button. The visualimage of the document is memorized and projected onthe screen. After changing the document, press this but-ton again. The visual image of the new document on thestage is projected on the screen.Notes:• The frame memory function works only when theinput selector is set to VIDEO IMAGER.!3 Nega Button (NEGA)This button is used to project a positive image of nega-tive film. Place the negative film on the stage and zoomto proper size. Then press this button, followed by thewhite balance button.!4 Power Switch (POWER)When turning the power on, the POWER indicator willlight.!5 Power Cord Connector (AC IN)!6 Audio Output Connectors (AUDIO OUT, L/R)An audio signal from an external source that is selectedwith the input selector and the microphone audio areprovided to the AUDIO OUT L/R connectors.Notes:• This appliance does not have a built-in power ampli-fier unit. Do not connect speakers to these connec-tors directly.• The audio supplied to the MIC IN connector isalways audible regardless of the position of the inputselector.!7 Composite Video Output Connector(VIDEO OUT)This connector supplies the 1.0V[p-p]/75 Ω compositevideo signal to the video monitor.!8 S-Video Output Connector (S-VIDEO OUT)This connector supplies the S-Video signal to the videomonitor.!9 Input Selector (INPUT SELECT: VIDEO IMAGER,A/V1, A/V2)This selector is used to select the audio/video signalfrom three sources.When VIDEO IMAGER is selected, the camera signal ofthe WE-MV180A is provided to the video output connec-tors.When both A/V1 and A/V2 are selected, the externalaudio/video signal is provided to the AUDIO OUT con-nectors (L/R), the S-VIDEO OUT connector, and theVIDEO OUT connector.@0 Microphone Input Connector(MIC IN −65 dB 600 Ω)This connector is used to connect the microphone.Note:Make sure that the specified microphone (−65 dB,600 Ω) is used.@1 Microphone Volume (MIC VOL)This dial is used to adjust the microphone volume.