Panasonic Viera VT50A series Operating Instructions Manual

Contents

Panasonic Viera VT50A series Operating Instructions Manual Manual pdf 35 page image

Viewing 3D images34Part names and functionsPower switchON / OFF● Slide the tab to the “ON” / “OFF” position to switch the powerOn / Off.MODE● Slide the tab to the “MODE” position to change the modebetween 3D and 2D (view a 3D image in 2D).● This is also used when registering the 3D Eyewear to the TV.For details “Registration” (see below)Indicator lampLights or flashes during use to show the status.Battery cover● When using for the first time, remove the insulating sheet. Pull theinsulating sheet.● To replace the battery “Replacing the battery” (p. 35)Insulating sheetPull■ Indicator lamp statusIndicator lamp StatusLights red for 2 seconds when turned on Sufficient battery levelFlashes 5 times when turned on Low battery levelFlashes red and green alternately Under registeringFlashes green once every 2 seconds Under reconnecting to the TVLights green for 3 seconds Registering or reconnecting is successfully completed.Flashes red 3 times Automatically power off (Registering or connecting failsor connection is lost)Flashes red once every 2 seconds when in use 3D mode is selectedFlashes red twice every 4 seconds when in use 2D mode is selectedRegistrationFirst registrationPerform the first registration when the 3D Eyewear is used for the first time.1 Turn the TV on2 Slide the power switch from “OFF” to “ON”The 3D Eyewear will be turned on and start registration.Place the 3D Eyewear within 50 cm from the TV while registration in progress.3 The green LED lights on the 3D Eyewear for 3 seconds when theregistration is successfully completedAfter first registration, the 3D Eyewear will reconnect with TV automatically when 3D Eyewear is turned on nearthe TV in 3D mode.