Panasonic Viera UT50A series Operating Instructions Manual

Also see for Viera TH-P42UT50Z: Service manual

Contents

Panasonic Viera UT50A series Operating Instructions Manual Manual pdf 34 page image

Viewing 3D images34RegistrationFirst registrationPerform the first registration when the 3D Eyewear is used for the first time.1 Turn on the TV2 Slide the power switch from “OFF” to “ON”The 3D Eyewear will power on and start registration.Place the 3D Eyewear within 50 cm from the TV while registration in progress.3 The green LED lights on the 3D Eyewear for 3 seconds when the registration is successfully completedAfter first registration, the 3D Eyewear will reconnect with TV automatically when 3D Eyewear is powered on near theTV in 3D mode.Registration againWhen connection with registered TV fails, or when using with another TV, re-register the 3D Eyewear.1 Turn on the TV2 Within 50 cm from the TV, hold the power switch on the “MODE” position for more than 2 secondsThe registration will start.3 The green LED lights for 3 seconds when the pairing is successfully completedNote● If the registration failed, the 3D Eyewear will power off. In this case, power off the TV and perform from step 1.● Release the power switch when Registration again starts.Viewing range for the 3D EyewearApprox.3.2 mNote● You cannot view the 3D images with the 3D Eyewear too far from the TV, because of the difficulty of receiving radiowaves from the TV.● The range may be shortened depending on the obstacles between the TV and the 3D Eyewear, or the surroundingenvironment.● There are differences in the viewing range of the 3D Eyewear among individuals.● The 3D Eyewear may not operate correctly at the outside of the viewing range.