Panasonic Viera TX-P42GT30E Operating Instructions Manual

Also see for Viera TX-P42GT30E: Service manual

Contents

Panasonic Viera TX-P42GT30E Operating Instructions Manual Manual pdf 88 page image

Using Network Services (DLNA / VIERA Connect)884 Select [Connection Test] and access to test---ab-cd-ef-gh-ij-klConnection TestNetwork TypeAccess Point SettingsIP/DNS SettingsNetwork Link SettingsSoftware UpdateMAC AddressNetwork SetupWiredAccessaccessselect• Performs automatic testing of the network connection for the TV. (It takes a whileto test.)Check network cable connection.Check acquired IP address.Check for devices using same IP address.Check gateway connection.Check server connection.Connection Test : succeededThe test is successful and the TV is connected to the network.: failedCheck the settings and connections, and then perform this function again.Wireless connection settingsThis setting is for the network connection by using the Wireless LAN Adaptor. (Wireless connection)• Confirm the encryption key, settings and positions of your access point before starting setup. For details, read the manual ofthe access point.1 Select [Network Type] and set to [Wireless]ab-cd-ef-gh-ij-klConnection TestNo settingsNetwork TypeAccess Point SettingsIP/DNS SettingsNetwork Link SettingsSoftware UpdateMAC AddressNetwork SetupWireless access / storeselect2 Select [Access Point Settings]ab-cd-ef-gh-ij-klConnection TestNetwork TypeAccess Point SettingsIP/DNS SettingsNetwork Link SettingsSoftware UpdateMAC AddressNetwork SetupWirelessNo settings accessselect3 Select the connection type and setConnection TypePlease select network connection type.WPS(Push button)WPS(PIN)Search for access pointManualaccessselect• For details of each connection type (p. 89, 90)• After settings, return to [Network Setup] screen4 Confirm the connection status of [Access Point Settings]ab-cd-ef-gh-ij-klConnection TestNetwork TypeAccess Point SettingsIP/DNS SettingsNetwork Link SettingsSoftware UpdateMAC AddressNetwork SetupWirelessConnected- - - : [Wired] is selected in [Network Type].[No adaptor] : Wireless LAN Adaptor is not connected.[No settings] : Setting for connecting to the access point has not been set.[Connecting...] : Connecting to the access point in progress.[Connected] : Wireless connection to the access point succeeded• To display the current access point settings, press the OKbutton.To change the settings, select [No] on this screen.• Some access points do not allow access to the internet.Perform [Connection Test] (p. 89) to check if internetconnection is available.[USB overcurrent] : Overcurrent error (p. 116)