5(Cleaning an energized TV may cause electrical shock.)When cleaning the TV, remove the mains plugCautionBlocked ventilation by curtains,etc. may cause overheating, fireor electrical shock.Do not block the rear air ventsNotesMaintenanceDisplay panelCabinetMains plugRegular care: Gently wipe the surface clean of dirt by using a soft cloth.Major contamination: Wipe the surface clean using a soft cloth dampened with clean water or diluted neutraldetergent by 100 times of water. Then, using a soft dry cloth, evenly wipe the surface clean until it is dry.Regular care: Wipe the surface clean using a soft dry cloth.Major contamination: Dampen a soft cloth with clean water or water containing a small amount of neutral detergent.Then, wring the cloth and wipe the surface clean with it. Finally, wipe the surface clean with a dry cloth.Wipe the mains plug with a dry cloth at regular intervals. (Moisture and dust may lead to fire or electrical shock.)First, remove the mains plug from the socket outlet.Caution• The surface of the display panel has been specially treated and may be easily damaged.Do not tap or scratch the surface with your fingernail or other hard object.• Use care not to subject the surface to bug repellent, solvent, thinner, or other volatile substances(this may degrade surface quality).Caution• Use care not to subject the TV's surfaces to detergent.(A liquid inside the TV could lead to product failure.)• Use care not to subject surfaces to bug repellent, solvent, thinner, or other volatile substances(this may deteriorate the surface by peeling the paint).• Do not allow the cabinet to make contact with a rubber or PVC substance for a long time.Electronic equipmentIn particular, do not place video equipment too closethe TV (electromagnetic interference may distortimages / sound).Equipment with an infrared sensorRemote Controller of this TV also emits infrared rays(this may affect operation of other equipment).Keep the TV away from these equipmentAdjust the LCD panel to your desiredangle15° 15°(View from the top)If no signal is received and no operation isperformed in TV mode for 30 minutes, the TV willautomatically go to standby mode.Auto power standby functionTransporting the TV with its display panelfacing upright or downward may causedamage to the internal circuitry.Transport only in upright positionRemove the mains plug from the wallsocket when TV is not in use for aprolonged period of time. Remove themains plug from the wall socket beforeconnecting or disconnecting any leads.This TV will still consume some power even inthe Standby mode, as long as the mains plugis still connected to a live socket outlet. On /Offswitch see page 7.Do not expose your ears to excessivesound pressure from headphones.Irreversible damage can be caused.Allow sufficient space around theTV for radiated heat101010 10(cm)TV StandMinimum distance