Panasonic Viera TX-26LMD71FA Operating Instructions Manual

Also see for TX-26LMD70FA: Service manual Service manual

Panasonic Viera TX-26LMD71FA Operating Instructions Manual Manual pdf 28 page image

28Tuning ChannelsOffDVB Signal ConditionDVB Programme [70] CBBC Channel0 5 10Signal QualitySignal StrengthSelects a channel and checks the DVB signal condition.Use for adjusting the direction of the aerial.Signal Quality:• Green bar Good• Yellow bar Poor• Red bar Bad (Check the aerial)• To change the programme during the menu appearsCheckDVB signalDVB SignalConditionDisplay anotificationmessageNew ServiceMessageNew DVB Service Found!Press OK to start Auto SetupPress EXIT to lgnore.Selecting Auto Setup will deletecurrent Profile and Childlock settingsSelects whether to give a notification message when a new DVB service is found. (Off / On)• Selecting OK (Auto Setup) will deletecurrent Profile and Childlock settings.Set DVBchannelmanuallyDVB ManualTuningNormally use “Auto Setup” or “Add New DVB Services” for the DVB channel setting.If tuning has not done completely, use this function.adjust frequency(set where the level of “Signal Quality”becomes the maximum)select channelsearchDVB Manual TuningSignal QualityStopped0 10Signal Strength 0 10Frequency MHz[CH21] 474,00Prog. Channel Net ID. QualityTS ID.Service Name• All services found will be added to theDVB Service List (p. 25) automatically.AddDVB channelautomaticallyAdd NewDVB ServicesAny new services found will be added to the DVB Service List (p. 25) automatically.ADD New DVB ServicesPlease waitThis will take about 3 mins.5 69Prog. Channel Service Name Net ID. TS ID. QualityZDFARDstart• The new service is added with the current settingssaved as they are.Set AnaloguechannelmanuallyAnalogueManual TuningFine TuningProgramme 1 [CH33]Analogue Manual TuningManual Tuning 2 1 4178ŶFine TuningUse to make small adjustments to the tuning of an individual channel (affected by weatherconditions, etc.)ŶManual TuningSet Analogue channel manually after Auto Setup.If a VCR is connected with only the RF cable, select programme position “0”.storesearchSearch and storeSelect the channelSelect the programme positionVCR1 324 657 980