Panasonic Viera TH-P50X30Z Operating Instructions Manual

Panasonic Viera TH-P50X30Z Operating Instructions Manual Manual pdf 73 page image

Frequently Asked Questions72Problem ActionsHDMISound is unusual• Set the sound setting of the connected equipment to “2ch L.PCM”.• Check the [HDMI1 / 2 / 3 Input] setting in the Sound Menu. (p. 27)• If digital sound connection has a problem, select analogue soundconnection. (p. 65)Pictures from externalequipment are unusualwhen the equipment isconnected via HDMI• Check the HDMI cable is connected properly. (p. 56, 61 - 63)• Turn the TV and equipment Off, then turn them On again.• Check an input signal from the equipment. (p. 66)• Use equipment compliant with EIA/CEA-861/861D.NetworkCannot connect to thenetwork• Check the LAN cable or Wireless LAN Adaptor is connected properly.(p. 48)• Check the connections and settings. (p. 48 - 51)• Check the network equipment and network environment.• If the problem persists, consult your Internet Service Provider ortelecommunications company.Cannot select thefile during DLNAoperations• Is the media server prepared? (p. 47)• Check applicable data format. (p. 67 - 68)Cannot access theInternet contents • Check the connections and settings. (p. 48 - 51)• The server or connected line might be busy now.Digital TVDue to the digital reception technologies involved, quality of the Digital TV signals may berelatively low in some cases, despite good reception of Analogue TV channels.Unable to receivesignals with ahigh-performanceaerial• Install an aerial individually for the TV and VCR (or use a splitter).(Individual aerial)(Individual aerial)Aerial InputTVVCRAerialInputterminalAerial OutputSplitterAerial OutputInterference orfrozen / disappearingimage in Digital TV• Check “Digital TV Signal Condition” (p. 32).If “Signal Quality” or “Signal Strength” are displayed in red, checkaerial. If problem persists, consult your local Panasonic dealer.• Turn the TV off with the Mains power On / Off switch, then turn it Onagain.OtherThe TV goes intoStandby mode• Auto power standby function is activated.• The TV enters Standby mode about 30 minutes after analoguebroadcasting ends.The remote controldoes not work or isintermittent• Are the batteries installed correctly? (p. 6)• Has the TV been switched On?• Point the remote control directly at the front of the TV (within about7 m and a 30 degree angle of the front of the TV).• Situate the TV away from sunshine or other sources of bright light notto shine on the TV’s remote control signal receiver.Parts of the TV becomehot• Even when the temperature of parts of the front, top and rear panelshas risen, these temperature rises will not pose any problems interms of performance or quality.

/ 76

Related manuals for Panasonic Viera TH-P42X30Z