FAQs, etc.• SD Card: On screen messages• Frequently Asked Questions44 45Problem ActionsDVBProblem ActionsOtherHDMI SD• Due to the digital reception technologies involved, quality of the DTV signals may be relatively low insome cases, despite good reception of analogue programmes.Sound is unusual• Set the sound setting of the connected equipmentto "2ch L.PCM".• Check the "HDMI1 input" setting in the Sound menu.(p. 16)• If digital sound connection has a problem, selectanalogue sound connection. (p. 38)TV unit goes into"Standby mode"• The sleep function is activated.• The TV unit enters "Standby mode" about 30 min.after broadcasting ends.An error messageappears• Follow the message's instructions.• If the problem persists, contact the authorizedService Centre.An error messageappears • Contact the authorized Service Centre.FAQsUnable to receivesignals with ahigh-performanceaerial• Install an aerial individually for the TV unit and VCR(or use a splitter).TVVCR(Individual aerial)(Individual aerial)AerialInputterminalSplitterAerial OutputAerial InputAerial Output"Control with HDMI"function does not work • Switch the TV unit on again with the equipment on.• Set “Control with HDMI” to “Off”, then set to “On” again.(p. 31)The SD card cannotbe used even when itis formatted • Contact the authorized Service Centre.SD Card: On screen messagesMessage Meaning/ActionCautions in handling SD Card :• Do not remove the card while the unit is accessing data ("blue" LEDOn) (this can damage card or unit).• Do not touch the pins on the back of the card.• Do not subject the card to a high pressure or impact.• Insert the card in the correct direction (otherwise, card may bedamaged).• Electrical interference, static electricity, or erroneous operation maydamage the data or card.• Back up the recorded data at regular intervals in case of deterioratedor damaged data or erratic operation of the unit. (Panasonic is notliable for any deterioration or damage of recorded data.)Blue LEDWARNING: As with an small object,SD card can be swallowed by youngchildren. Do not allow children tohandle SD card. Please remove SD cardimmediately after use.Is SD Card in?• Insert a SD card.SD Card is lockedPlease unlock to operate • Unlock the SD card.This file is lockedPlease unlock to operate • Unlock the file in the card.This type of format is notsupported • The unit does not support the format.(For the applicable formats and data, see p. 40.)This type of card is notsupported • A card not supported by the unit has been inserted.(For the supported cards, see p. 40.)Broken fileCannot display image • The file is broken.Memory full• The card memory is full.Not enough memory• The card does not have enough memory to operate.Cannot read file• The file is not readable.Unrecordable sourceSD recording is stopped • That channel cannot be recorded.(Recording is automatically stopped.)ErrorCheck card • Re-insert the card. If the error persists, format the card. (p. 29)Card recording in progressPlease stop recording to operate • That operation is not available during recording.To continue the operation, stop recording.( For example, changing channels while recording a TVprogramme. )Delete file? • Displayed when you press Red colour button to delete aMPEG4 file. Press OK button to confirm deleting.No time dataCannot store time info • Since the signal does not have the time information, the date isrecorded as 01/01/2000.