English 13OperationTurn power on(TV)or(Remote Control)● Mains power On / Off switch should be on. (p. 12)The last viewed [Home Screen] is displayed.Example: [TV Home Screen]Example: Selected content screen● To return to [Home Screen] at any time● The [Home Screen] can be set up to display desiredinformation, to access specific features easily, toselect the default [Home Screen], etc. For details,follow the on-screen instructions or refer to [eHELP](my Home Screen > my Home Screen).Watching TV1 Select the TV viewer from [HomeScreen]selectaccess2 Select Digital TV or Analogue TVTick the TV signal mode to tune, and then select[Start Auto Tuning]: tune (search for the available channels): skip tuning3 Select the type of [Home Screen]The demonstration to explain how to use [my HomeScreen] feature is displayed. Follow the demonstrationby following the on-screen instructions, and then selectthe desired [Home Screen].Example: [Home Screen Selection]Example: [TV Home Screen]Auto Tuning is now complete and theTV is ready for viewing.If tuning has failed check the RF cable, and the networkconnection, and then follow the on-screen instructions.Note● The TV goes into Standby mode when no operationis performed for 4 hours if [Auto Standby] in the TimerMenu is set to [On].● The TV goes into Standby mode when no signalis received and no operation is performed for 10minutes if [No signal Power off] in the Timer Menu isset to [On].● To retune all channels[Auto Tuning] in [Tuning Menu] (Setup Menu)● To add the available TV signal mode later[Add TV Signal] in [Tuning Menu] (Setup Menu)● To initialise all settings[Shipping Condition] in [System Menu] (SetupMenu)