39AdvancedEditing and Setting ChannelsAutomatically searches and adds available channels to the memory.Select “ANT in”Select “Cable” or “Antenna”or select “Not used” (p. 13).Select “Auto program”MenuCableANT/Cable setupANT inAuto programManual programSignal meternextselectSelect a scanning mode (p. 13)Menu Auto programAll channelsAnalog onlyDigital onlyOKselectSettings are made automaticallyAfter the scanning is completed, select “Apply”.(see below ).All previously saved channels are erased.Use this procedure when changing the channel setup orchanging the channel display.Also, use this to add or skip channels from the channel listmanually.You can select a channel tuning mode (Digital only/Analogonly) in “Channel surf mode”(p. 29)EditCaption---80-101Edit CH captionCaptionChannelOKRETURNDeleteABC → abcR G B YSelect@ D A changesetorCaptionSelect or edit the station identifier.(maximum 7 characters available)FavoriteSet favorite 1/326-112selectsetSet favorite Select the numberAddPress OK to select “Yes (add)” or “No (skip)”Move the cursor to a channel numberManual programEdit CancelApplyCaption Favorite Add2 ...... Yes3 ...... YesChannelselectpress OK to tuneto the channelSelect “Apply”programCancelApplyCaption Favorite Add...... YeselselectOKSelect “Edit”Manual programEdit CancelApplyCaption Favorite Add2 ...... Yes3 ...... Yes4 ...... Yes5 ...... YesChannelselectnextSelect the item to editR G B YSelectRETURNOKManual programEdit CancelApplyCaption Favorite Add2 ...... Yes3 ...... Yes4 ...... Yes5 ...... Yes6 ...... Yes7 ...... Yes8 ...... Yes9 ...... YesChannelPrev.page Next pageCaptionFavoriteAddProceed tonext pageGo back to the previouspageselect the i temto edit (Caption/Favorite/Add)next• Caption:Changes the station identifier• Favorite:Registers channels to theFavorite List• Add:Adds or skips channelsTo cancel the EditManual programEdit CancelApplyCaption Favorite Add2 ...... Yes3 ...... Yes4 ...... Yes5 ...... YesChannelselectnextChanges will be lost. Continue?Yes No OK(returns to “ANT/Cable setup”)select “Yes”Check the signal strength if interference is found or freezing occurs on a digital image.MenuSelects which channel to be tested for signalstrength.--Signal meterChannelSignal strengthCurrent 86%Peak level 98%changechannelOKorSignal intensityIf the signal is weak, check the antenna.If no problem is found, consult your local dealer.NoteNot available if “Cable” is selected in “ANT in” (see above).Available only for digital antenna channels.If “Lock” (p. 36) is activated and “ANT/Cable setup” is selected, “Enter password.” will be displayed.