Panasonic Viera TC-L32X30 Owner's Manual

Also see for VIERA TC-L32X30: Service hints Owner's manual Owner's manual Owner's manual Owner's manual

Panasonic Viera TC-L32X30 Owner's Manual Manual pdf 12 page image

12First Time SetuporTurn the TV On with the POWER buttonor(Remote)(TV)Configure your viewing modeSelect your languageLanguage / Idioma / LangueEnglish Español FrançaisStep 1 of 7 / Paso 1 de 7 / Étape 1 de 7OKSelectSelecciónSélectionSelect your languageSeleccione su idiomaSélection de la langueselectOKSelect your countryStep 2 of 7RETURNOKSelectCountrySelect the country where this TV is being used.U.S.A. Canada OtherselectOKSelect your viewing mode (Be sure to select “Home use”)Step 3 of 7RETURNOKSelectSet viewing modeHome use Store DemonstrationSelect your viewing environmentselectOKƔ Please confirm your selection (Home Use) before pressing OK button.ŶIf you select “Store Demonstration” by mistake in ,confirmation screen will be displayed.NoYou are selecting the store demonstration mode.If you select “Yes”, the picture mode will regularly resetto “Vivid” and a Picture Refresh message will be displayed on thescreen.Yes selectOKƔ Select “No” and return to previous screen .Ɣ If you select “Yes”, Screen enters the store demonstration mode.To display the “Set viewing mode” screen again as shown above andselect “Home Use”, do one of the following:• Press and hold down the side POWER button for at least five seconds.• Unplug power cord for 30 seconds and plug it again.NoteƔ If you use any other step other than then turn the TV off, or if you usedthe EXIT button to quit before completing the settings, the next time you turnthe TV on, “First time setup” will not be automatically displayed.• The settings up to that point are saved.• You can start “First time setup”. (p. 52)Ɣ Language, ANT/Cable setup, Input labels, Clock can also be changed fromthe Settings Menu. (p. 52)The first time setup screen is displayed only when the TV is turned on for the first time after the power cordis inserted into a wall outlet and when “Auto power on” (p. 52) is set to “No”.