5Do not display a still picture for a long timeThis causes the image to remain on the plasma screen(“Image retention”). This is not considered a malfunction and is not covered by the warranty.4 : 3 12 To prevent the “Image retention”, the screen saver isautomatically activated after a few minutes if no signals aresent or no operations are performed.Typical still images• Channel number and other logos• Image displayed in 4:3 mode• SD Card photo • Video game • Computer imageSet upDo not place the unit where it’s exposed to sunlight or other bright light (including reflections).Use of some types of fluorescent lighting may reduce the remote control’s transmission range.NotesFCC STATEMENTThis equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCCRules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with theinstructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will notoccur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can bedetermined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of thefollowing measures:• Reorient or relocate the receiving antenna.• Increase the separation between the equipment and receiver.• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.• Consult the dealer or an experienced radio/TV technician for help.This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device maynot cause harmful interference, and (2) this device must accept any interference received, including interference that may causeundesired operation.FCC Caution:To assure continued compliance, follow the attached installation instructions and use only shielded interface cableswhen connecting to computer or peripheral devices. Any changes or modifications not expressly approved byPanasonic Corp. of North America could void the user’s authority to operate this device.FCC Declaration of ConformityModel No. TC-42PX24, TC-50PX24Responsible Party: Panasonic Corporation of North AmericaOne Panasonic Way, Secaucus, NJ 07094Contact Source: Panasonic Consumer Electronics Company1-877-95-VIERA (958-4372)email: consumerproducts@panasonic.comCANADIAN NOTICE:For Model TC-42PX24, TC-50PX24This Class B digital apparatus complies with Canadian ICES-003.