10General OperationPush the Volume Up or Down buttonto increase or decrease the soundvolume level.Volume Adjustment5.6.Push this button to mute the Soundcompletely.Push the button once again to restorethe previous sound level, and cancelthe mute.Sound Mute ButtonPush the RECALL button to displaythe current system status.Press this button until display iscancelled.Recall ButtonThe " Mute " symbol will appear.( Colour changes to Red )7.8.Off Timer ButtonThe TV set may be preset toswitch to stand-by after a fixedperiod.By pressing "Off-Timer" button,you can select the preset time either30, 60, or 90 minutes.When the off-timerreaches its last 3minutes, it starts blinkingbefore going to stand-bycondition.Note :30 60 90AUTO0119.AV 17AV 2AV 3+–Note :The on screen display willindicate both numerically andgraphically the volume level.Numeric levels start at " 0 " forzero or no sound, and willincrease up to 63 which is themaximum sound level.TV/AV303– – – – – – – – – – –5oHow to cancel the OFF-timer setting:Push the " TV/AV " button to select TV, AV1, AV2 and AV3 inputsignal modes sequentially.Note:If a clear picture cannot be obtained or even when a AV signalis received, refer to the “Colour System Selection” operation onpage 19.TV / AV SelectionSetting Off-timer to AUTO mode.If the set is not switched off, when the TV station ends broadcasting, it will automaticallygo to the stand-by condition after 5 minutes. This AUTO mode will not operate when the TV receiver is in AV mode.1. Set the preset time condition to "0" mode by pressing the Off -timer button.2. Turning the TV set off.– – – – – – – – – – –5