Supplied accessories for installation*1Mounting base × 1 Screw × 4(4 mm × 12 mm)Screw × 2(3.8 mm × 20 mm)Name plate × 2(incl. 1 spare)Hex wrench × 1*1 VL-V555BX/SX models onlyImportant:R You will need the following additional items to install and configure the doorphone. [Locallyprocured]– Screw × 2 (for mounting base): VL-V555EX/FX models onlyPrepare the screws ( → the drawing on the right) according to the material,structure, strength and other factors of the mounting area and the total weightof objects to be mounted.4 mm– Wires (for doorphone and other connections):Prepare cables and wires of the appropriate specification.Note:R In the event of problems, you should contact your equipment supplier in the firstinstance.R VL-V555EX/FX/BX models only: Please refer to the "General information" section in the Video IntercomSystem Operating Instructions for information regarding the R&TTE Directive.R The illustrations in the supplied manual(s) may vary slightly from the actual product.Location of controlsFABCDEGA Lens coverB LED lights– Used to illuminate the visitor’s face or the area in front ofthe doorphone so that the vistor’s face can be seen in thedark.C Name plate (supplied accessory)– Can be attached as required when installing thedoorphone.D MicrophoneE Camera lensF SpeakerG Call button and indicator (red)– Lights in red when the power is on.Doorphone image qualityThe following phenomena may occur. They are not malfunctions.R If strong light such as sunlight shines into the camera lens, uneven colouring from reflected light, orwhite lines or circles may appear in images.R Images may appear distorted because of the characteristics of the camera lens.R When there is poor light in the area around the doorphone or at night:– Areas lit with external lights or white objects may appear greenish.– Even when the doorphone’s LED lights are lit, because the light from the LED lights cannot illuminatethe edges of the visible area (the areas directly next to the doorphone), faces of people may not beidentifiable even when they are close to the doorphone.(We recommend installing extra lights in the area around the doorphone.)SpecificationsPower source Power supplied by the main monitorDimensions (mm) (height × width × depth) Approx. 169 × 118 × 30 (excluding protruding sections)Mass (weight) Approx. 395 gOperating environment Ambient temperature: approx. -15 °C to +55 °CRelative humidity (non-condensing): up to 90 %Viewing angle*1 Horizontally: approx. 170°Vertically: approx. 130°Installation method Wall mount (mounting base supplied)Minimum illuminance required 1 lx (within approx. 50 cm from the camera lens)Lighting method LED lightsIP rating IP54*2IK rating Compliant with IK07*1 When connected to the Video Intercom System VL-SVN511 series.*2 Water resistance is only assured if the doorphone is installed correctly according to the instructionsin the Installation Guide, and appropriate water protection measures are taken.Note:R Design and specifications are subject to change without notice.R Names, company names, product names, software names, and logos mentioned in this manual aretrademarks or registered trademarks of the companies concerned.