Panasonic VL-DM200BX Operating Instructions Manual

Also see for VL-DM200BX: Operating instructions

Contents

Panasonic VL-DM200BX Operating Instructions Manual Manual pdf 10 page image

– Recharge the battery pack before using the Wireless Monitor again.Pairing to the Base UnitR The Wireless Monitor ( ) can be used by pairing it to the Base Unit ( )*1 of the WirelessDoor Camera.1 *1: Plug the AC adaptor of the Base Unit into the power outlet.2 *1: Press and hold the pair button (B) located on the bottom side of the Base Unit*1 forabout 3 seconds with a pointed object.R Stop pressing the pair button (B) when the pair indicator (A) starts to slowly flash.*1>AB3 : Place the additional Wireless Monitor ( ) on the Base Unit ( )*1, and thenpress MMENUN.R Press MMENUN within 2 minutes of performing step 2.4 : Press M N (Monitor button) to start pairing.R When pairing is completed, “PAIRING COMPLETED” is displayed.Note:R Pairing cannot be performed when another Wireless Monitor is accessing the Base Unit*1 (formonitoring or other purposes).R The monitor number of the Wireless Monitor to be paired cannot be specified.*1 Base Unit of the VL-SDM200BX.To pair canceled Wireless MonitorsR Perform the following operations within 2 minutes after pressing and holding the pair button of theBase Unit ( ) as explained in step 1 and 2 above.1 Press MMENUN.2 Select “ALL SETTINGS” by pressing arrow keys (MDN, MCN, MFN, or MEN), then press M N (Monitorbutton) (“OK”).3 Select “PAIRING/CANCEL” by pressing MDN or MCN, then press M N (Monitor button) (“OK”).4 Select “PAIRING” by pressing MDN or MCN, then press M N (Monitor button) (“OK”).5 Select “MONITOR”, then press M N (Monitor button) (“OK”).6 Press M N (Monitor button).7 To finish the operation, press MMENUN 2 times.10Getting Started